follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Speed By Design
Register Garage Community Calendar Today's Posts Search

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Search Forums
Reload this Page Search Results


Page 1 of 4 1 234
Showing results 1 to 30 of 109
Search took 0.01 seconds. Search: Posts Made By: stevo585
Forum: Engine, Exhaust, Transmission 08-14-2018, 08:55 PM
Replies: 34
Views: 6,525
Posted By stevo585
Absolutely a myth. At some point the VVT would be...

Absolutely a myth. At some point the VVT would be sluggish or get CEL maybe. That's if say an 0w-40 in cold temps. On the track it be thin enough to be fine. Remember the WRX is essential the same...
Forum: Forced Induction 10-24-2017, 10:21 PM
Replies: 29
Views: 11,708
Posted By stevo585
I run zero supporting mods. I just watch oil and...

I run zero supporting mods. I just watch oil and coolant temps. I run a 30wt oil though. Stock clutch still holding ok. Tuned to near perfection.
Forum: Forced Induction 05-20-2017, 10:41 PM
Replies: 28
Views: 9,711
Posted By stevo585
WM injection is also a lot cheaper than FF up...

WM injection is also a lot cheaper than FF up front. Probably about 50% cheaper as you need FF kit + injectors + fuel pump to run e85.
Forum: Mechanical Maintenance (Oil, Fluids, Break-In, Servicing) 04-21-2017, 07:35 PM
Replies: 29
Views: 7,914
Posted By stevo585
With the longer drain intervals its not the TBN...

With the longer drain intervals its not the TBN to worry about it the oil shearing too low or out of grade. The OP's shows 6.5 cst which is on the low side on a 20wt. That's way too thin IMO.
Forum: Issues | Warranty | Recalls / TSB 04-09-2017, 11:23 PM
Replies: 96
Views: 32,997
Posted By stevo585
IAM = ignition advance multiplier. That means...

IAM = ignition advance multiplier. That means full timing. Which is around 20 degrees iirc in the stock map.

If my local fuel was that bad Id blend with toluene or some other octane booster like...
Forum: Forced Induction 03-22-2017, 09:26 PM
Replies: 30
Views: 14,264
Posted By stevo585
Isnt safe to say that *any* forged rod will be...

Isnt safe to say that *any* forged rod will be better than oem by far? Why all the worry?
Forum: Forced Induction 02-25-2017, 10:28 PM
Replies: 79
Views: 38,698
Posted By stevo585
Support American manufacturing! ;)

Support American manufacturing! ;)
Forum: Engine Swaps 01-15-2017, 12:12 AM
Replies: 139
Views: 111,393
Posted By stevo585
So you swapped an NA 200hp motor for a 200hp NA...

So you swapped an NA 200hp motor for a 200hp NA motor seems hmm
Forum: Forced Induction 12-08-2016, 10:11 PM
Replies: 11,295
Views: 3,460,720
Posted By stevo585
It is true it is essentially a non-existent...

It is true it is essentially a non-existent product. The "wait list" is kinda irrelevant too.

I was going to do a twin setup but I know Ill likely never get another kit.

So I may...
Forum: Forced Induction 11-30-2016, 09:22 PM
Replies: 11,295
Views: 3,460,720
Posted By stevo585
Well I'm in the top quarter and I have been on...

Well I'm in the top quarter and I have been on the list since April 2015. So thats 18 or so months already.

I already have a used kit but I want a twin setup for shits and giggles.
Forum: Forced Induction 10-14-2016, 12:43 PM
Replies: 11,295
Views: 3,460,720
Posted By stevo585
Looks like that extra psi up top will be good for...

Looks like that extra psi up top will be good for an extra 10-20whp.
Forum: Engine, Exhaust, Transmission 08-12-2016, 02:00 PM
Replies: 31
Views: 7,327
Posted By stevo585
304 is 304. I use it pretty much daily at work....

304 is 304. I use it pretty much daily at work. The difference in quality is usually the lack of passivation or other secondary treatments. It will last just fine. Like any brand name you pay for the...
Forum: Engine, Exhaust, Transmission 08-12-2016, 10:05 AM
Replies: 31
Views: 7,327
Posted By stevo585
Yes I have noticed surface rust on the asian made...

Yes I have noticed surface rust on the asian made cheap exhausts. They usually use 201 SS that's not passivated as you tell by surface spot rust. However in my experience some blue magic can clean...
Forum: Forced Induction 08-11-2016, 12:03 AM
Replies: 1,206
Views: 362,117
Posted By stevo585
Really? I activate mine all the time. A least a...

Really? I activate mine all the time. A least a few times a day. Just quick 3-5 second bursts.
Forum: Forced Induction 08-01-2016, 04:10 PM
Replies: 1,206
Views: 362,117
Posted By stevo585
Wow how do you have so much boost? That's the V2...

Wow how do you have so much boost? That's the V2 TQ250 right?
Forum: Forced Induction 07-19-2016, 09:59 PM
Replies: 32
Views: 15,663
Posted By stevo585
I have the ESC kit its pretty good for the price...

I have the ESC kit its pretty good for the price - used. Not sure about full price of 2100 + tune. Also dont need any supporting mods other than a tune. Gives a modest 40hp and 70lb tq maybe a bit...
Forum: Forced Induction 07-12-2016, 03:36 PM
Replies: 11,295
Views: 3,460,720
Posted By stevo585
I did say "not sure if they...". I could have...

I did say "not sure if they...". I could have said "Those guys never rode...". So you know I was unsure and trying to be passive but I get your point. Now I understand you have experience. But as you...
Forum: Forced Induction 07-11-2016, 10:57 PM
Replies: 11,295
Views: 3,460,720
Posted By stevo585
I think in reality this is all irrelevant to the...

I think in reality this is all irrelevant to the OP because you can't buy the kit anyways. What is the wait list time? Close to 2 years now I assume. Its been 16 months for me and I'm still about...
Forum: Forced Induction 07-11-2016, 04:27 PM
Replies: 11,295
Views: 3,460,720
Posted By stevo585
Wow that is a big difference between V1 and the...

Wow that is a big difference between V1 and the latest at least up top. Looking at the torque app boost is very dependent of atmospheric conditions.

I seem to not have your issues though. Hot and...
Forum: Forced Induction 07-11-2016, 02:54 PM
Replies: 11,295
Views: 3,460,720
Posted By stevo585
I know you and I'm local. Next time at a CF86...

I know you and I'm local. Next time at a CF86 meet I'll take you out. I really don't think you'll be that impressed though in this summer heat it really kills performance. What he said about keeping...
Forum: Forced Induction 06-29-2016, 09:24 PM
Replies: 1,206
Views: 362,117
Posted By stevo585
Yeah even 20-30 seconds is alot! I'm always 3-10...

Yeah even 20-30 seconds is alot! I'm always 3-10 seconds on the street. At just 13.8 seconds I'm already at 101 mph...
Forum: Forced Induction 05-27-2016, 12:19 AM
Replies: 8
Views: 3,144
Posted By stevo585
ok well 235 isnt crazy if your on a 5w30wt oil....

ok well 235 isnt crazy if your on a 5w30wt oil. On a 0w20 thats going to be sub optimal oil pressure.
Forum: Engine, Exhaust, Transmission 05-26-2016, 09:55 PM
Replies: 683
Views: 364,894
Posted By stevo585
Right thats similar to investment casting (lost...

Right thats similar to investment casting (lost wax).
Forum: Engine, Exhaust, Transmission 05-24-2016, 09:02 PM
Replies: 683
Views: 364,894
Posted By stevo585
Graphite or sand cast them and make a side...

Graphite or sand cast them and make a side business. :D Laser the flanges and weld them.

Those flutes/runners machined are going to be expensive as hell though for a one off. I would guess...
Forum: Forced Induction 05-09-2016, 10:50 PM
Replies: 1,206
Views: 362,117
Posted By stevo585
It was probably wheel hop as I did a dry burnout....

It was probably wheel hop as I did a dry burnout. Then bogged even after a 4k launch.

14.2 @ 99.5. Too warm kills performance I have done much better in cool weather. I also was only 2.3 on the 60...
Forum: Forced Induction 05-08-2016, 11:08 PM
Replies: 1,206
Views: 362,117
Posted By stevo585
1/4 mile pass this friday May 6th. track run 1...

1/4 mile pass this friday May 6th.
track run 1 - YouTube
Forum: Tracking / Autocross / HPDE / Drifting 05-02-2016, 11:22 PM
Replies: 420
Views: 231,756
Posted By stevo585
Whats a good pad for a novice just into HDPE's? I...

Whats a good pad for a novice just into HDPE's? I plan on swapping to torque 700 brake fluid....overkill? Recommend a good fluid? Thanks.
Forum: Forced Induction 04-20-2016, 08:22 PM
Replies: 1,206
Views: 362,117
Posted By stevo585
"If the ESC is turned off, technically it would...

"If the ESC is turned off, technically it would cause a slight air restriction, but likely nothing that would be of consequence".

Not exactly. My MAF was off 10% with it installed when I did my...
Forum: Forced Induction 04-07-2016, 03:39 PM
Replies: 1,206
Views: 362,117
Posted By stevo585
No.. its not for sale :D ...sorry maybe in a...

No.. its not for sale :D ...sorry maybe in a year. Not sure I want to put 5k+ into this car that ill never get back.
Forum: Forced Induction 04-06-2016, 08:17 PM
Replies: 1,206
Views: 362,117
Posted By stevo585
I actually have a first year kit. It's used....

I actually have a first year kit. It's used. Unlike most I run a custom Ecutek street tune with both 93 and 2x e85 maps saved in the ecu. Otherwise my setup is in my sig. I do have a stock catback...
Showing results 1 to 30 of 109
Page 1 of 4 1 234

 
Forum Jump

All times are GMT -4. The time now is 07:47 PM.

Contact Us - Toyota GR86, 86, FR-S and Subaru BRZ Forum - FT86CLUB - Archive - Privacy Statement - Terms of Service/DMCA Policy - Top

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.