follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Delicious Tuning
Register Garage Community Calendar Today's Posts Search

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Search Forums
Reload this Page Search Results

Register and become an FT86Club.com member. You will see fewer ads

Page 1 of 3 1 23
Showing results 1 to 30 of 65
Search took 0.01 seconds. Search: Posts Made By: 86league
Forum: Tracking / Autocross / HPDE / Drifting 12-17-2024, 01:33 PM
Replies: 2
Views: 1,563
Posted By 86league
Might look here - same discussion :...

Might look here - same discussion : https://www.ft86club.com/forums/showthread.php?t=154086
Forum: Engine, Exhaust, Transmission 11-16-2024, 05:22 PM
Replies: 2
Views: 684
Posted By 86league
Well - I have my answer. Clutch disk...

Well - I have my answer.


Clutch disk failed - damper springs worked sideways and jammed against the pressure plate springs while holding the disk against the flywheel.

...
Forum: Engine, Exhaust, Transmission 11-15-2024, 04:55 PM
Replies: 2
Views: 684
Posted By 86league
Help diagnosing clutch non-release?

Hi.


My 2020 BRZ fairly suddenly got to where the clutch is not releasing and the trans input shaft is always spinning with the engine. Clutch-in cranking moves the vehicle if it's in gear. ...
Forum: Mechanical Maintenance (Oil, Fluids, Break-In, Servicing) 06-30-2024, 06:44 PM
Replies: 44
Views: 16,516
Posted By 86league
I know this thread is old, but I disassembled a...

I know this thread is old, but I disassembled a BRZ transmission with 3-4 shift issues and 2 metal balls on the drain plug magnet.


I can confirm what AxisPower says in Post 29/31 - these are...
Forum: Tracking / Autocross / HPDE / Drifting 06-06-2024, 12:30 PM
Replies: 11
Views: 3,019
Posted By 86league
I do run ABS, but no TC (pedal dance). ABS was...

I do run ABS, but no TC (pedal dance). ABS was my first thought too - although the dots are not exactly what I'd seen from ABS in the past. But -- I had several sets of rotors where I was REALLY...
Forum: Engine, Exhaust, Transmission 12-03-2023, 11:37 PM
Replies: 58
Views: 16,824
Posted By 86league
2 (all?) of the dowels were very corroded and...

2 (all?) of the dowels were very corroded and hard to get unstuck when I took the transmission out of my 2013. I mentioned it to the SA/Tech next time I was at the dealer and they just nodded and...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 11-23-2023, 09:11 PM
Replies: 27
Views: 13,364
Posted By 86league
They are about 2x the spring rate of the stock...

They are about 2x the spring rate of the stock springs. In my case I can for sure feel the higher rates - the car follows up/down motions in the road more closely. Impacts are not worse - probably...
Forum: Wheels | Tires | Spacers | Hub -- Sponsored by The Tire Rack 05-04-2023, 07:06 PM
Replies: 59
Views: 14,168
Posted By 86league
The six 17x9 ARC-8 wheels I've had have come in...

The six 17x9 ARC-8 wheels I've had have come in 0.3+ lbs heavier than spec. Pretty close, but a little off.
Forum: Engine, Exhaust, Transmission 08-16-2022, 05:02 PM
Replies: 11
Views: 3,946
Posted By 86league
FWIW, i had a hard time getting my 2013 separated...

FWIW, i had a hard time getting my 2013 separated too. The dowel pins had corroded and (I think) were a big part of hanging things up. Agree though - you need the engine/trans to be at the right...
Forum: Other Vehicles & General Automotive Discussions 06-29-2022, 03:49 PM
Replies: 1,913
Views: 319,265
Posted By 86league
I can see this having advantages and...

I can see this having advantages and disadvantages. Makes for fewer number of charge points needed for normal times, but that could make holiday travel a mess (well more of a mess than it is now...
Forum: Wheels | Tires | Spacers | Hub -- Sponsored by The Tire Rack 05-17-2022, 03:48 PM
Replies: 11
Views: 1,837
Posted By 86league
IDK why there would be any difference with the...

IDK why there would be any difference with the hub based on what caliper/rotor they bolt on. I put the 28373CA000 on my PP equipped car and they looked to be identical to what I took off and work...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 04-04-2022, 06:52 PM
Replies: 19
Views: 4,514
Posted By 86league
My issue went away with replacing just the one...

My issue went away with replacing just the one front hub. I don't think there was really anything wrong with the passenger side front hub, but I got the parts for free, so I replaced it anyway. I...
Forum: Tracking / Autocross / HPDE / Drifting 04-04-2022, 04:18 PM
Replies: 1
Views: 1,061
Posted By 86league
Thoughts on Hawk ER-1 pad?

From the marketing these sound to be fairly decent, and seem to be priced fairly well.

https://www.hawkperformance.com/ER-1

They say the changed the formulation, but I assume they would have...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 04-04-2022, 04:05 PM
Replies: 19
Views: 4,514
Posted By 86league
I recently had a similar issue. It turned out to...

I recently had a similar issue. It turned out to be the hub. I replaced rotors/pads and the problem was still there. Replaced the hub/wheel bearing and the vibration/brake shudder went away. The...
Forum: BRZ Second-Gen (2022+) — General Topics 02-15-2022, 06:04 PM
Replies: 473
Views: 151,922
Posted By 86league
8.5" vs 9" wheel at the same ET isn't going to...

8.5" vs 9" wheel at the same ET isn't going to give you 0.5" less poke - it will be 0.25" less poke and 0.25" more inner clearance.

My ARC-8 17x9 ET42 wheels with 245 SX2s on a friends 2022 poked...
Forum: GR86 General Topics (2nd Gen 2022+ Toyota 86) 02-10-2022, 12:07 AM
Replies: 9
Views: 2,350
Posted By 86league
I think stock are 18mm with a 6mm backing plate ...

I think stock are 18mm with a 6mm backing plate
PP Brembo are ~15mm with a 5mm backing plate

Carbotech matched the numbers above for the stock. For the Brembo, Cobalt says 15.3, but the PFC...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 11-08-2021, 01:15 PM
Replies: 34
Views: 11,207
Posted By 86league
First track weekend with the Whiteline front sway...

First track weekend with the Whiteline front sway and endlinks. Driver side endlink attach to the swaybar came loose EVERY session. I had used blue locktite when installing and had really torqued...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 09-29-2021, 04:52 PM
Replies: 34
Views: 11,207
Posted By 86league
I've tried various settings - ended up a little...

I've tried various settings - ended up a little on the "stiffer" side than the initial track recommendation. Depending on the track I vary a click or two.

I'm trying to tune out some understeer...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 09-27-2021, 03:13 PM
Replies: 47
Views: 8,025
Posted By 86league
I think those numbers are wrong. His piston...

I think those numbers are wrong. His piston sizes don't match measured values.

https://www.ft86club.com/forums/showpost.php?p=3417897&postcount=17
Forum: Other Vehicles & General Automotive Discussions 09-23-2021, 04:51 PM
Replies: 70
Views: 16,660
Posted By 86league
Will be interesting to see what Lotus comes up...

Will be interesting to see what Lotus comes up with : https://arstechnica.com/cars/2021/09/heres-how-lotus-is-going-to-build-lightweight-electric-sports-cars/

And to see if this is all just talk...
Forum: Tracking / Autocross / HPDE / Drifting 08-23-2021, 01:22 PM
Replies: 24
Views: 4,970
Posted By 86league
You are on currently on RT660s right now if I...

You are on currently on RT660s right now if I read your other posts correctly - so you are saying those are not lasting as long as the RS4s? When I first read this I thought you were saying the new...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 08-04-2021, 06:07 PM
Replies: 4
Views: 1,497
Posted By 86league
You asking about a specific vendor or part...

You asking about a specific vendor or part numbers?

For part numbers, did you see the list here? : https://www.ft86club.com/forums/showthread.php?t=144662
Forum: BRZ Second-Gen (2022+) — General Topics 06-21-2021, 04:19 PM
Replies: 145
Views: 36,319
Posted By 86league
Wonder how long this will last. There may not be...

Wonder how long this will last. There may not be a very much inventory for them to sell/hold on to.

https://www.autonews.com/manufacturing/subaru-idle-two-japan-plants-july-16-due-chip-shortage
Forum: Issues | Warranty | Recalls / TSB 06-05-2021, 06:54 PM
Replies: 21
Views: 4,104
Posted By 86league
Sorry you have to deal with that. I just got...

Sorry you have to deal with that. I just got done getting mold/mildew out of my car's passenger footwell carpet after a wet track weekend.

I put the "sandbags" I used to hold down my ez-up in...
Forum: Issues | Warranty | Recalls / TSB 06-05-2021, 04:39 PM
Replies: 21
Views: 4,104
Posted By 86league
Depends on the year I think - my 2013 had etorx,...

Depends on the year I think - my 2013 had etorx, but my 2020 is just a standard metric hex head.
Forum: Tracking / Autocross / HPDE / Drifting 06-02-2021, 06:19 PM
Replies: 24
Views: 4,970
Posted By 86league
Listened to a webcast today about this tire, they...

Listened to a webcast today about this tire, they had someone from Hoosier/Continental give a presentation and answer questions.

Sounds like they benchmarked the Hankook RS4 and they think they...
Forum: DIY (Do-It-Yourself) Guides 06-02-2021, 11:52 AM
Replies: 317
Views: 198,986
Posted By 86league
Updated original post with the thingiverse link.

Updated original post with the thingiverse link.
Forum: DIY (Do-It-Yourself) Guides 04-27-2021, 08:13 PM
Replies: 317
Views: 198,986
Posted By 86league
I had just joined thingiverse to upload this. It...

I had just joined thingiverse to upload this. It showed up for me with that link, but it also tells me I need to wait 24 hrs to publish as a new member.

I went back and published it. Let me know...
Forum: Cosmetic Modification (Interior/Exterior/Lighting) 04-07-2021, 06:04 PM
Replies: 46
Views: 11,191
Posted By 86league
If it's feeling noticeably less grippy at only...

If it's feeling noticeably less grippy at only 80, I'd make sure the basics are right before adding downforce.

How's the alignment?
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 03-29-2021, 08:45 PM
Replies: 68
Views: 49,554
Posted By 86league
To clarify - That image and #'s are for the...

To clarify - That image and #'s are for the non-brembo/stock brake system and was taken from this thread : https://www.ft86club.com/forums/showthread.php?t=140940 attempting to calculate the bias of...
Showing results 1 to 30 of 65
Page 1 of 3 1 23

 
Forum Jump

All times are GMT -4. The time now is 03:16 AM.

Contact Us - Toyota GR86, 86, FR-S and Subaru BRZ Forum - FT86CLUB - Archive - Privacy Statement - Terms of Service/DMCA Policy - Top

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2025 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.