jrhudson
|
Last Activity: 08-21-2023 01:00 AM
Trader Rating
| iTrader Profile | Recent Ratings | ||||||||||||||||||||||||||||||||||||
|
|
||||||||||||||||||||||||||||||||||||
Positive
Neutral
Negative
Mentions
| 05-25-2022 |
| 02:30 PM - jrhudson mentioned Ultramaroon in post Transmission rattle in Neutral ...letely disappears. Ultramaroon |
| 02-06-2022 |
| 06:15 AM - jrhudson mentioned steve99 in post P0016 fixable without new ECU? ...ut 100. just follow steve99's guide on it. https... |
| 01-29-2022 |
| 11:11 PM - jrhudson mentioned steve99 in post Replacing a Bricked damaged or faulty ECU with new or used ECU FRS BRZ GT 86 ...t but thanks to steve99 assisting me in turn... |
| 09-12-2021 |
| 11:43 PM - jrhudson mentioned humfrz in post New Short Block; New Leaks ...r then i agree with humfrz. |
| 09-10-2021 |
| 08:59 PM - jrhudson mentioned FrickingReallySlow in post New motor starts then dies. FrickingReallySlow i did another reflas... |
| 09-09-2021 |
| 11:29 PM - jrhudson mentioned FrickingReallySlow in post New motor starts then dies. ...AF is disconnected. FrickingReallySlow spotted that my fuel... |
| 08-11-2021 |
| 10:48 PM - jrhudson mentioned NoHaveMSG in post Valve clearances on built block ...out. thanks to NoHaveMSG and bobel. I wa... |
| 10:48 PM - jrhudson mentioned bobel in post Valve clearances on built block ... NoHaveMSG and bobel. I wanted to give so... |
| 08-05-2021 |
| 11:52 PM - jrhudson mentioned NoHaveMSG in post Valve clearances on built block Thanks to NoHaveMSG, i got to this point... |
| 07-18-2021 |
| 05:52 PM - jrhudson mentioned fableluke in post PCV question ...at 9 to an 8 like fableluke says.
https://part... |
| 05-24-2021 |
| 12:27 AM - jrhudson mentioned humfrz in post Subaru BRZ strange squeal/screeching noise while accelerating/decelerating ...e same way, do says humfrz change the accessory... |
| 05-13-2021 |
| 05:57 PM - jrhudson mentioned Denstoj in post FA20 Rocker Retainer Kit ...t of it. Good thing Denstoj did.
At 7:58 is whe... |
| 04-24-2021 |
| 12:29 AM - jrhudson mentioned Ultramaroon in post Rebuild motor or built short block? So Ultramaroon might actually be ri... |
| 04-10-2021 |
| 08:30 PM - jrhudson mentioned NoHaveMSG in post Rebuild motor or built short block? ...uys are saying is. NoHaveMSG signature applies he... |
| 08:02 PM - jrhudson mentioned NoHaveMSG in post Rebuild motor or built short block? ...ually unthreaded.
NoHaveMSG
About turning the cr... |
Quotes
| 04-24-2021 |
| 03:55 AM - jrhudson quoted Ultramaroon in post Rebuild motor or built short block? Bent valves. :(
I don't kno... |
| 04-23-2021 |
| 02:06 PM - jrhudson quoted DarkPira7e in post built motor with 12.5:1 compression? Not to mention timing component... |
| 02:39 AM - Ultramaroon quoted jrhudson in post Rebuild motor or built short block? say whaaaat?
So the hole mi... |
| 01:41 AM - jrhudson quoted Ultramaroon in post Rebuild motor or built short block? I wouldn't write it off quite ye... |
| 12:34 AM - Ultramaroon quoted jrhudson in post Rebuild motor or built short block? Ahh, I see.
the crankshaft... |
| 04-22-2021 |
| 11:41 PM - jrhudson quoted NoHaveMSG in post Rebuild motor or built short block? Runout is essentially checking... |
| 09:31 PM - jrhudson quoted NoHaveMSG in post Rebuild motor or built short block? Wish the circumstances where b... |
| 08:59 PM - NoHaveMSG quoted jrhudson in post Rebuild motor or built short block? Yo youre the best! No sure if... |
| 08:48 PM - jrhudson quoted NoHaveMSG in post Rebuild motor or built short block? I was thinking thread it in an... |
| 08:44 PM - NoHaveMSG quoted jrhudson in post Rebuild motor or built short block? I did try that. It wont budge... |
| 08:27 PM - jrhudson quoted NoHaveMSG in post Rebuild motor or built short block? Did you pull the crank pulley ... |
| 08:45 AM - Breadman quoted jrhudson in post built motor with 12.5:1 compression? Well, my turbo is carb legal.... |
| 02:45 AM - jrhudson quoted Breadman in post built motor with 12.5:1 compression? Compression shouldn't affect ... |
| 02:45 AM - jrhudson quoted Ashikabi in post built motor with 12.5:1 compression? Compression shouldn't affect ... |
| 04-21-2021 |
| 03:02 AM - jrhudson quoted tomm.brz in post built motor with 12.5:1 compression? dont know about smog but
You... |
| 04-16-2021 |
| 07:44 AM - jrhudson quoted Denstoj in post FA20 Rocker Retainer Kit Update -
Due to demand, ... |
| 04-15-2021 |
| 10:03 AM - DarkPira7e quoted jrhudson in post FR-S Turbo Build Awesome build! Cant wait for ... |
| 04-11-2021 |
| 06:08 AM - jrhudson quoted Ultramaroon in post Rebuild motor or built short block? Staying tuned. One thing. Prom... |
| 01:41 AM - Ultramaroon quoted jrhudson in post Rebuild motor or built short block? this might have actually happ... |
| 01:23 AM - jrhudson quoted Ultramaroon in post Rebuild motor or built short block? I had the same feeling but my ne... |