Hags86
Senior Member |
Last Activity: 01-13-2022 04:38 PM
Trader Rating
iTrader Profile | Recent Ratings | ||||||||||||||||||||||||||||||||||||
|
|
About Me
- About Hags86
- Car
- Toyota GTS 86
- Location
- Melbourne Australia
-
Signature
- 2013 Toyota 86: 275rwkW
Coyoda Water-to-air Intercooled Turbo with GTX2863. CP Carillo Rods and Pistons. Motec M150 ECU. Motec C125 Dash. Holinger SG 6 Speed Sequential Gearbox. OS Giken LSD. MCA Reds Coilover. AP Racing Essex Sprint Front Brakes. PWR Radiator and Intercooler heat exchanger.
- 2013 Toyota 86: 275rwkW
Mentions
02-06-2018 |
02:27 PM - Hags86 mentioned Lunatic in post Does anyone make a decent - functional - splitter I like your ideas Lunatic and jonesy. I'm doin... |
02:27 PM - Hags86 mentioned jonesy in post Does anyone make a decent - functional - splitter ...r ideas Lunatic and jonesy. I'm doing something... |
06-30-2017 |
01:39 AM - Hags86 mentioned coyote in post Coyoda Turbo Kit Thread. coyote. I sent you a PM. ... |
06-07-2014 |
04:17 PM - Chad86 mentioned Hags86 in post Where Do You Set Your Rev Limiter? ...
Photo courtesy of Hags86
http://www.ft86club.... |
Quotes
01-15-2022 |
09:49 AM - Kiske quoted Hags86 in post Recommend me a race turbo setup I'm after the best engineer... |
01-13-2022 |
04:38 PM - Hags86 quoted x808drifter in post Recommend me a race turbo setup How do you expect a air-to-air i... |
04:38 PM - Hags86 quoted tomm.brz in post Recommend me a race turbo setup How do you expect a air-to-ai... |
09-12-2019 |
12:48 AM - FR_STEEZ quoted Hags86 in post Throttle Position Sensor [Suspected Faulty] So, I installed a new accel... |
05-31-2019 |
06:13 PM - Hags86 quoted DarkPira7e in post Who Uses Oil Scavenging Pump for Turbo Drain Haha oh no, don't tell me this.... |
05-22-2019 |
08:01 PM - DarkPira7e quoted Hags86 in post Who Uses Oil Scavenging Pump for Turbo Drain I found the TurboWerx is ov... |
05-04-2019 |
07:40 AM - Hags86 quoted SirSpectre in post Lower compression effects Good info. Pulled the trigger o... |
05-03-2019 |
05:35 PM - wparsons quoted Hags86 in post Lower compression effects Stay with 12.5:1 because
... |
05-01-2019 |
11:05 AM - ATL BRZ quoted Hags86 in post Lower compression effects Stay with 12.5:1 because
... |
04-02-2019 |
08:14 AM - Trap63 quoted Hags86 in post AIT relocation - Bias resistor values - HKS SC - ECUTEK Do you have a multimeter ha... |
02-13-2019 |
11:55 AM - Arcadien Angel quoted Hags86 in post Dual Oil Coolers in "fog light duct" area? Here is mine. About to star... |
01-05-2019 |
11:09 AM - Irace86.2.0 quoted Hags86 in post Reliability on turbo 86 Oil pressure at low RPM is ... |
04:14 AM - Hags86 quoted StraightOuttaCanadaEh in post Reliability on turbo 86 The question that's been boiling my noodle... |
01-02-2019 |
07:35 AM - Hags86 quoted Boris_Petrov in post Reliability on turbo 86 Hags86 what power exactly did you... |
07:30 AM - Hags86 quoted Irace86.2.0 in post Reliability on turbo 86 I really don't understand the di... |
07:27 AM - Boris_Petrov quoted Hags86 in post Reliability on turbo 86 I debated lowering the comp... |
11-12-2018 |
09:38 AM - Joesurf79 quoted Hags86 in post Fuel pressure setting I'm installing a surge tank... |
10-09-2018 |
06:48 AM - Jaden quoted Hags86 in post Well... I'm Australian based and pr... |
09-19-2018 |
05:39 AM - thornad quoted Hags86 in post RPF1 17x7.5 +48mm Does anyone know if RPF1 1... |
08-28-2018 |
11:11 PM - Hags86 quoted CSG Mike in post Can you help me? Build engine.
Big turbo.
... |