ZDan
|
Last Activity: 04-09-2026 12:57 AM
Trader Rating
| iTrader Profile | Recent Ratings | ||||||||||||||||||||||||||||||||||||
|
|
||||||||||||||||||||||||||||||||||||
Positive
Neutral
Negative
Mentions
| 08-03-2013 |
| 08:29 AM - arghx7 mentioned ZDan in post 2014 C7 Chevrolet Corvette ...gets tricky, where @ZDan has a good point. T... |
| 08-02-2013 |
| 10:42 PM - Dimman mentioned ZDan in post 2014 C7 Chevrolet Corvette ...m, I highly respect ZDan 's and arghx7 's tec... |
| 07-24-2013 |
| 01:28 AM - CSG Mike mentioned ZDan in post BRZ vs. Prelude Si vs. S2000. . . Initial Thoughts ...ith both of you...
ZDan: Have you purchased ... |
| 03-05-2013 |
| 03:51 AM - switchlanez mentioned ZDan in post New Subaru BRZ Accessory Catalogs for 2013 ...tter at analyzing. @ZDan or @Shankenstein, wo... |
| 03-04-2013 |
| 05:32 PM - switchlanez mentioned ZDan in post Simple explaination of HP vs Torque, using an FRS as an example.. ...) = T(t)*w(t)
As @ZDan mentioned, we are pl... |
| 02-07-2013 |
| 07:45 PM - bestwheelbase mentioned ZDan in post 2014 Toyota Tundra ...ied by this call.
ZDan I'm with ya. Some fo... |
| 02:02 AM - Dimman mentioned ZDan in post Part critique please ZDan - Motorsports doesn'... |
| 01-30-2013 |
| 11:47 PM - Dimman mentioned ZDan in post 2014 C7 Chevrolet Corvette ... bit of a challenge ZDan a couple times, with... |
| 01-29-2013 |
| 11:27 AM - CSG Mike mentioned ZDan in post Best Tire for Aggressive Street Use ...22 years straight?
ZDan: http://www.s2ki.com... |
| 01-13-2013 |
| 03:21 AM - Dimman mentioned ZDan in post 2013 Mustang GT or wait for 2015 Mustang GT or new model 370Z (390Z)...??? ...That's kinda cool.
ZDan also keep in mind wh... |
Quotes
| 03-20-2018 |
| 07:41 AM - ZDan quoted Irace86.2.0 in post Official: Toyota FT-1 Concept / First New Supra Prototype Spotted! I’ve been trying to figure out h... |
| 03-06-2018 |
| 07:55 AM - ZDan quoted Dee in post Alignment question Found my before and afte... |
| 03-05-2018 |
| 03:45 PM - Dee quoted ZDan in post Alignment question So you were using camber ... |
| 10:42 AM - ZDan quoted Dee in post Alignment question So to make this short, t... |
| 03-01-2018 |
| 02:42 PM - Tcoat quoted ZDan in post PP Brembos & Wet Conditions I ran into the same thing... |
| 02-28-2018 |
| 02:46 PM - CSG Mike quoted ZDan in post Wheels/tires for daily-driver & time trials... I'm about to start gettin... |
| 01:32 PM - Jamestl quoted ZDan in post Wheels/tires for daily-driver & time trials... Thanks, if I go camber bo... |
| 01:10 PM - ZDan quoted Jamestl in post Wheels/tires for daily-driver & time trials... You could try two sets of ca... |
| 12:24 PM - Jamestl quoted ZDan in post Wheels/tires for daily-driver & time trials... I sold the OEM tires, win... |
| 11:11 AM - ZDan quoted 14stu in post Wheels/tires for daily-driver & time trials... You do not want to daily d... |
| 10:46 AM - ZDan quoted venturaII in post Wheels/tires for daily-driver & time trials... Then there's always the cascad... |
| 02-27-2018 |
| 03:05 PM - venturaII quoted ZDan in post Michelin Pilot Sport 4S available OEM size for our cars I had the opposite experi... |
| 12:23 PM - ZDan quoted venturaII in post Michelin Pilot Sport 4S available OEM size for our cars Don't forget that it's easy to... |
| 02-24-2018 |
| 05:58 PM - ZDan quoted jamal in post Ohlins updated it's R&T coil-over for our car If front and rear tires ar... |
| 05:28 PM - ZDan quoted jamal in post Ohlins updated it's R&T coil-over for our car The other thing is with a ... |
| 02-21-2018 |
| 06:54 PM - AnthonyArcaro quoted ZDan in post Looking for some help on fitment Comp 2 A/S looks good and... |
| 07:58 AM - ZDan quoted AnthonyArcaro in post Looking for some help on fitment Thanks man, I'm probably going to ... |
| 07:53 AM - AnthonyArcaro quoted ZDan in post Looking for some help on fitment How'd you end up with tha... |
| 07:50 AM - ZDan quoted Alfrz91 in post Alignment after getting new tires, was this even necessary?(Pic included) I'm very far from being an e... |
| 07:36 AM - ZDan quoted AnthonyArcaro in post Looking for some help on fitment Recently I purchased 18x8 +35 whee... |
