Gopherboy6956
|
Last Activity: 09-04-2024 12:28 AM
Trader Rating
| iTrader Profile | Recent Ratings | ||||||||||||||||||||||||||||||||||||
|
|
||||||||||||||||||||||||||||||||||||
Positive
Neutral
Negative
About Me
- About Gopherboy6956
- Car
- 13 BRZ Limited WRB
- Location
- Fargo, ND
-
Signature
- I plan to live forever. So far, so good.
My Build - http://www.ft86club.com/forums/showthread.php?t=31925
- I plan to live forever. So far, so good.
Mentions
| 06-27-2022 |
| 05:55 PM - ka-t_240 mentioned Gopherboy6956 in post WTB: Heavily Modified '15/'16 Gopherboy6956 ready to sell yours?... |
| 12-13-2017 |
| 01:32 AM - Gopherboy6956 mentioned CSG in post Compression Ratio for Supercharged w/ Vortech ...he 12.5 CR pistons. CSG Mike - Pricing on th... |
| 09-28-2017 |
| 01:53 AM - Gopherboy6956 mentioned Xero-Limit in post Before I pull the Motor... again... Situation Update. I went an thr... |
| 04-28-2017 |
| 05:59 PM - Gopherboy6956 mentioned glamcem in post Antigravity Small Case Batterys Any update on this glamcem? |
| 04-02-2017 |
| 11:30 PM - phrosty mentioned Gopherboy6956 in post OFT - Warning about the company ...ally ignoring you.
Gopherboy6956 When you called them... |
| 03-30-2017 |
| 07:04 PM - Gopherboy6956 mentioned Shiv@Openflash in post OFT - Warning about the company ...used.
I contacted Shiv@Openflash by phone, he said th... |
| 04-26-2016 |
| 11:31 AM - Gopherboy6956 mentioned Shiv@Openflash in post Ecutek VS OFT - Should I Switch? ...uner. At this time, Shiv@Openflash is going to e-tune w... |
| 03:51 AM - Kodename47 mentioned Gopherboy6956 in post Ecutek VS OFT - Should I Switch? ...in getting into.
Gopherboy6956 you don't have to bu... |
| 12:17 AM - Gopherboy6956 mentioned Jeff in post Tune out Engine Rasp 3800 - 4400rpm ...t, I was talking to JeffPerrin today and he s... |
| 09-13-2015 |
| 07:00 PM - Blu-by-U mentioned Gopherboy6956 in post Minnesota Check In ....2, many thanks to @Gopherboy6956 for the ride in a bi... |
| 04-07-2015 |
| 12:05 AM - Gopherboy6956 mentioned Dezoris in post Minnesota Check In ... it vs someone like Dezoris initial kit) and the... |
| 12:05 AM - Gopherboy6956 mentioned PERRIN in post Minnesota Check In ...eloped the Kit with PERRIN, who I have worked w... |
| 12-07-2014 |
| 10:05 PM - Gopherboy6956 mentioned PERRIN_Mladen in post Vortech Supercharging - FAQ and Notes ... insight?
Talk to @PERRIN_Mladen at Perrin. He'll gi... |
| 10:04 PM - Gopherboy6956 mentioned ML in post Vortech Supercharging - FAQ and Notes ...t?
Talk to @PERRIN_Mladen at Perrin. He'l... |
| 08-29-2014 |
| 10:21 PM - Dipstik-sportech mentioned Gopherboy6956 in post Minnesota Check In I rode in Gopherboy6956 's car at the first ... |
| 08-20-2014 |
| 07:23 PM - Blu-by-U mentioned Gopherboy6956 in post Minnesota Check In ...(9/7) only HPDE)
2. Gopherboy6956 - AutoX Friday, Satu... |
| 04-16-2014 |
| 02:21 PM - supramkivtt2jz mentioned Gopherboy6956 in post DIY Warning - Removing the Crank Pulley ...iginal pulley like @Gopherboy6956 suggested, then use ... |
| 04-14-2014 |
| 01:48 AM - Deleted Posts |
| 01:47 AM - Deleted Posts |
| 01:46 AM - Deleted Posts |
Quotes
| 10-26-2019 |
| 06:26 PM - bfrank1972 quoted Gopherboy6956 in post Vortech Owner Thread & Setup Questions Hmm not sure why that was so tough... |
| 10-25-2019 |
| 11:32 PM - Gopherboy6956 quoted bfrank1972 in post Vortech Owner Thread & Setup Questions Thanks so I had the old belt on... |
| 11:44 AM - bfrank1972 quoted Gopherboy6956 in post Vortech Owner Thread & Setup Questions Yep - so that's the trick - you ha... |
| 12:52 AM - Gopherboy6956 quoted bfrank1972 in post Vortech Owner Thread & Setup Questions Hi fellow vortech folks, instal... |
| 06-21-2019 |
| 05:55 PM - Mykii quoted Gopherboy6956 in post Anybody running Exedy stage 2 clutch? Here's an accurate image of how th... |
| 06-20-2019 |
| 05:35 PM - Gopherboy6956 quoted Mykii in post Anybody running Exedy stage 2 clutch? Well, I'm under 10miles on... |
| 05-29-2019 |
| 12:11 PM - Jamestl quoted Gopherboy6956 in post P&L Header install, review and impressions How'd you get the Damn 3rd nut on ... |
| 03-13-2019 |
| 05:17 PM - Gopherboy6956 quoted JD001 in post Battery Recommendations? What's going on here??? Th... |
| 05:14 PM - JD001 quoted Gopherboy6956 in post Battery Recommendations? Hey All - Quick question -
My OE... |
| 05:10 PM - mrg666 quoted Gopherboy6956 in post Battery Recommendations? I just bought a Braille AGM - not ... |
| 03-12-2019 |
| 12:44 PM - Gopherboy6956 quoted ka-t_240 in post Battery Recommendations? Just make sure you disconnect... |
| 10:58 AM - ka-t_240 quoted Gopherboy6956 in post Battery Recommendations? After doing some looking - I think... |
| 03-09-2019 |
| 02:37 PM - why? quoted Gopherboy6956 in post Battery Recommendations? Also - following the thread that J... |
| 03:33 AM - JIM THEO quoted Gopherboy6956 in post Battery Recommendations? Also - following the thread that J... |
| 12:23 AM - Gopherboy6956 quoted JIM THEO in post Battery Recommendations? Something like this?
https:/... |
| 03-08-2019 |
| 04:59 AM - JIM THEO quoted Gopherboy6956 in post Battery Recommendations? Any specific model?
Something lik... |
| 02-26-2019 |
| 02:20 AM - Gopherboy6956 quoted Wes_TSi in post ECU and Engine Tuning Reference Guide Forgive me for resurrecting,... |
| 06-12-2018 |
| 12:11 PM - pgranberg11 quoted Gopherboy6956 in post @pete.lete - Gridlife StreetMod Build - Team Falken I actually just sent a sample from... |
| 06-09-2018 |
| 10:19 PM - enomadra quoted Gopherboy6956 in post Vortech on 2.87 pulley? So - Stock is 3.48, then there's 3... |
| 05-27-2018 |
| 11:35 PM - Gopherboy6956 quoted D_Thissen in post Newly Built FA20 - Vortech - e85 - Starting Issues I'll be honest man I didn't lo... |
