|
||||||
| Issues | Warranty | Recalls / TSB Problems, issues, recalls, TSBs |
 |
|
|
Thread Tools | Search this Thread |
06-17-2013, 04:32 PM
|
#1 |
|
Senior Member
Join Date: Jan 2012
Drives: A lot of supercars.
Location: USA
Posts: 495
Thanks: 237
Thanked 148 Times in 90 Posts
Mentioned: 5 Post(s)
Tagged: 0 Thread(s)
|
CEL P0456
Evaporative Emission Control System Leak Detected (Very Small Leak). Has anyone else had this problem? Last edited by Carwhisperer; 06-18-2013 at 06:49 PM. |
|
|
|
06-17-2013, 05:57 PM
|
#2 |
|
Some say.....
Join Date: Jun 2012
Drives: 2007 Subaru Impreza 2.5i
Location: Kitchener ON
Posts: 483
Thanks: 810
Thanked 310 Times in 174 Posts
Mentioned: 12 Post(s)
Tagged: 2 Thread(s)
|
Tighten your gas cap. Sounds silly, but that's usually all that will be.
|
|
|
|
| The Following User Says Thank You to BatStig For This Useful Post: | Carwhisperer (06-17-2013) |
|
06-17-2013, 05:59 PM
|
#3 |
|
Member
Join Date: Jun 2013
Drives: 2013 white brz
Location: Alabama
Posts: 83
Thanks: 2
Thanked 10 Times in 9 Posts
Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
|
Probably gas cap?
|
|
|
|
| The Following User Says Thank You to 256brz2013 For This Useful Post: | Carwhisperer (06-17-2013) |
|
06-17-2013, 06:12 PM
|
#4 |
|
Senior Member
Join Date: Dec 2011
Drives: Moped
Location: CA
Posts: 4,298
Thanks: 4,897
Thanked 2,128 Times in 1,193 Posts
Mentioned: 21 Post(s)
Tagged: 0 Thread(s)
|
^^^^X3
Yup, I've seen this code before and all that needed to be done was retighten the gas cap to make it go away... |
|
|
|
| The Following User Says Thank You to Lonewolf For This Useful Post: | Carwhisperer (06-17-2013) |
|
06-17-2013, 06:28 PM
|
#5 |
|
Senior Member
Join Date: Jan 2012
Drives: A lot of supercars.
Location: USA
Posts: 495
Thanks: 237
Thanked 148 Times in 90 Posts
Mentioned: 5 Post(s)
Tagged: 0 Thread(s)
|
I made sure it was tight, reset the code and drove it around, no cel yet. But, I was curious and loosened up the cap and drove it again and no CEL popped up. I'm going to drive it around tomorrow and see if it'll pop up again with the cap loose.
|
|
|
|
|
06-18-2013, 06:16 PM
|
#6 |
|
Senior Member
Join Date: Jan 2012
Drives: A lot of supercars.
Location: USA
Posts: 495
Thanks: 237
Thanked 148 Times in 90 Posts
Mentioned: 5 Post(s)
Tagged: 0 Thread(s)
|
So today I got the exact same CEL again after work right when I started up the car. Its not my gas cap. Its tight. I drove home and I went through almost 2x as much gas as I normally do ( 12 mile commute ) and went through almost a gallon of gas. I've had DI seal issues in the past. Wondering if this is related. Nothing is leaking to the ground which is worrysome.
|
|
|
|
|
06-18-2013, 06:19 PM
|
#7 |
|
Senior Member
Join Date: Apr 2012
Drives: 86 ZN6
Location: SF Bay Area, NorCal
Posts: 4,682
Thanks: 1,317
Thanked 2,072 Times in 1,222 Posts
Mentioned: 126 Post(s)
Tagged: 1 Thread(s)
|
Anyone get P0451 codes?
|
|
|
|
| The Following User Says Thank You to 86_ZN6 For This Useful Post: | whataboutbob (10-31-2013) |
|
06-18-2013, 06:52 PM
|
#8 |
|
Senior Member
Join Date: Dec 2011
Drives: Moped
Location: CA
Posts: 4,298
Thanks: 4,897
Thanked 2,128 Times in 1,193 Posts
Mentioned: 21 Post(s)
Tagged: 0 Thread(s)
|
Well the easy solution isn't the answer this time...
On my stepmom's bmw it was a $1,000 repair to make this cel go away...  Time for another dealer/warranty visit |
|
|
|
|
06-18-2013, 06:55 PM
|
#9 |
|
Senior Member
Join Date: Jan 2012
Drives: A lot of supercars.
Location: USA
Posts: 495
Thanks: 237
Thanked 148 Times in 90 Posts
Mentioned: 5 Post(s)
Tagged: 0 Thread(s)
|
awesome..
|
|
|
|
|
06-18-2013, 07:44 PM
|
#10 |
|
Senior Member
Join Date: Aug 2011
Drives: 2013 FRS Asphalt
Location: SF Bay Area
Posts: 1,155
Thanks: 309
Thanked 335 Times in 212 Posts
Mentioned: 21 Post(s)
Tagged: 0 Thread(s)
|
Check any vacuum lines. Last time I had that code it was due to a pinched vacuum hose line after installing a cai. Different car though.
__________________
2013 Scion FR-S AT Picked up 5/30/2012
|
|
|
|
| The Following User Says Thank You to feldy For This Useful Post: | Carwhisperer (06-18-2013) |
|
06-18-2013, 08:12 PM
|
#11 | |
|
Senior Member
Join Date: Jan 2012
Drives: A lot of supercars.
Location: USA
Posts: 495
Thanks: 237
Thanked 148 Times in 90 Posts
Mentioned: 5 Post(s)
Tagged: 0 Thread(s)
|
Quote:
|
|
|
|
|
|
06-18-2013, 10:31 PM
|
#12 |
|
Senior Member
Join Date: Jan 2012
Drives: A lot of supercars.
Location: USA
Posts: 495
Thanks: 237
Thanked 148 Times in 90 Posts
Mentioned: 5 Post(s)
Tagged: 0 Thread(s)
|
My engine has been lifted out 2 times for DI seal replacements. Would that have anything to do with a possible vacuum hose line if it was related to how the mechanic put it back in?
|
|
|
|
|
07-08-2013, 09:52 PM
|
#13 | |
|
Love Boost!!!!!!!!
Join Date: Jun 2012
Drives: Whiteout Scion FR-S
Location: Long Island NY
Posts: 3,612
Thanks: 429
Thanked 902 Times in 606 Posts
Mentioned: 87 Post(s)
Tagged: 3 Thread(s)
|
Quote:
__________________
༼ つ ◕_◕ ༽つ I LOVE BOOST ༼ つ ◕_◕ ༽つ
|
|
|
|
|
|
07-08-2013, 10:19 PM
|
#14 | |
|
Senior Member
Join Date: Apr 2012
Drives: 86 ZN6
Location: SF Bay Area, NorCal
Posts: 4,682
Thanks: 1,317
Thanked 2,072 Times in 1,222 Posts
Mentioned: 126 Post(s)
Tagged: 1 Thread(s)
|
Quote:
|
|
|
|
|
|
|
|
|
|
|
|
