2015 CWest BRZ FBM GT2871R - Page 2 - Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community

DHitHim · 05-30-2016, 02:06 PM

Got a few updates from last month to now.

Had Creative Auto Lab from Clovis, CA mould the Cwest rear to the bumper. Looks a whole lot nicer now. Finished it just in time for the Fresno Area Subaru Trust aka F.A.S.T. Little Big Meet.

Photo by John of Convex Photography at LBM. I won first place at the car show! Did know I was gonna even win LOL. It was by the people's vote too.

Went to Morro Bay to snap some photos.

DHitHim · 05-30-2016, 02:10 PM

On the way back home from Santa Barbara 2 weeks ago I destroyed my Wasp Composites splitter. Totally my fault and considered an installation error. I should have bought about it when k installed the SCraft lip. Maxing out the splitter rods to the last few threads was stupid on my part and I should have known better that a piece of aero would need more than a few threads to hold especially at higher speeds. The air pressure in my engine bay also caused the side markers to pop off too. That or side markers just suck.

DHitHim · 05-30-2016, 02:11 PM

DHitHim · 05-30-2016, 02:14 PM

Finally installed my rear stainless lines for Lone Pine Time Trials that I did last week. Pretty much a high speed autox w/ up to triple digit speeds.

DHitHim · 05-30-2016, 02:16 PM

Destroyed my Bridgestone S04 265/35 18 at Lone Pine Time Trials. I got a good 11k miles out of them with autox and canyon driving out of them.

Replaced it with Nitto NT01 245/40.

Looks pretty meaty

DHitHim · 06-09-2016, 01:46 AM

Picked up new wheels to daily/autox/track (LOL I don't daily this car though). Didn't want to roll around on NT01s

Wedsport 17x9 TC105N on 255/40 Rivals

This past weekend I did 2 days at Buttonwillow

Ran stock tire since I am new. I'd rather lose traction at low speed than at a higher speed with stickier tire.

May 27th I also installed my Greddy Oil Cooler which I totally fucked up by not tightening the sandwich plate all the way. I bukake'd my engine bay with oil on a test drive for leaks. That was a pain to clean too.

DHitHim · 06-16-2016, 01:30 PM

Picked up a Tommy Kaira/Rowen exhaust. This thing is beautiful! Love the way it sounds!

Ry.ruzn · 06-16-2016, 08:00 PM

I like the fact that you're doing most of the changes yourself to the car. Nothing like learning as you go. Seems like it's becoming expensive in your end though. Haha

DHitHim · 06-17-2016, 11:44 PM

Installed my Radium dual catch can kit today.

DHitHim · 06-19-2016, 02:46 AM

Installed my whiteline rear crossmember bushings earlier tonight. Will see how it is tomorrow at autox!

DHitHim · 07-28-2016, 04:03 AM

Quote:

Originally Posted by Ry.ruzn

I like the fact that you're doing most of the changes yourself to the car. Nothing like learning as you go. Seems like it's becoming expensive in your end though. Haha

HAHA yeah really expensive. Just bought more stuff and updated the section for awaiting install in the OP.

DHitHim · 07-28-2016, 04:16 AM

Took the car to Streets of Willow in CCW configuration earlier this month.

[ame="https://www.youtube.com/watch?v=07zh9MXiG5w"]https://www.youtube.com/watch?v=07zh9MXiG5w[/ame]

here's some photos.

Then this past weekend went to Bass Lake with my @clint_111 to take our dogs to the lake.

DHitHim · 08-31-2016, 04:16 AM

DHitHim · 09-30-2016, 02:18 AM

Well here's a huge update. I installed an FBM GT2871R kit.

Reflect A Gold the Oil Pan

05-30-2016, 02:06 PM	#15
DHitHim Senior Member Join Date: Feb 2015 Drives: 2015 CWP Limited BRZ Location: Clovis, California Posts: 200 Thanks: 68 Thanked 46 Times in 38 Posts Mentioned: 1 Post(s) Tagged: 0 Thread(s)	Got a few updates from last month to now. Had Creative Auto Lab from Clovis, CA mould the Cwest rear to the bumper. Looks a whole lot nicer now. Finished it just in time for the Fresno Area Subaru Trust aka F.A.S.T. Little Big Meet. Photo by John of Convex Photography at LBM. I won first place at the car show! Did know I was gonna even win LOL. It was by the people's vote too. Went to Morro Bay to snap some photos. __________________ addictedcollectibles.r/My IG '86 E30 (Project) 'VARIS Widebody http://www.ft86club.com/forums/showthread.php?t=103676

05-30-2016, 02:10 PM	#16
DHitHim Senior Member Join Date: Feb 2015 Drives: 2015 CWP Limited BRZ Location: Clovis, California Posts: 200 Thanks: 68 Thanked 46 Times in 38 Posts Mentioned: 1 Post(s) Tagged: 0 Thread(s)	On the way back home from Santa Barbara 2 weeks ago I destroyed my Wasp Composites splitter. Totally my fault and considered an installation error. I should have bought about it when k installed the SCraft lip. Maxing out the splitter rods to the last few threads was stupid on my part and I should have known better that a piece of aero would need more than a few threads to hold especially at higher speeds. The air pressure in my engine bay also caused the side markers to pop off too. That or side markers just suck. __________________ addictedcollectibles.r/My IG '86 E30 (Project) 'VARIS Widebody http://www.ft86club.com/forums/showthread.php?t=103676

05-30-2016, 02:11 PM	#17
DHitHim Senior Member Join Date: Feb 2015 Drives: 2015 CWP Limited BRZ Location: Clovis, California Posts: 200 Thanks: 68 Thanked 46 Times in 38 Posts Mentioned: 1 Post(s) Tagged: 0 Thread(s)	__________________ addictedcollectibles.r/My IG '86 E30 (Project) 'VARIS Widebody http://www.ft86club.com/forums/showthread.php?t=103676

05-30-2016, 02:14 PM	#18
DHitHim Senior Member Join Date: Feb 2015 Drives: 2015 CWP Limited BRZ Location: Clovis, California Posts: 200 Thanks: 68 Thanked 46 Times in 38 Posts Mentioned: 1 Post(s) Tagged: 0 Thread(s)	Finally installed my rear stainless lines for Lone Pine Time Trials that I did last week. Pretty much a high speed autox w/ up to triple digit speeds. __________________ addictedcollectibles.r/My IG '86 E30 (Project) 'VARIS Widebody http://www.ft86club.com/forums/showthread.php?t=103676

05-30-2016, 02:16 PM	#19
DHitHim Senior Member Join Date: Feb 2015 Drives: 2015 CWP Limited BRZ Location: Clovis, California Posts: 200 Thanks: 68 Thanked 46 Times in 38 Posts Mentioned: 1 Post(s) Tagged: 0 Thread(s)	Destroyed my Bridgestone S04 265/35 18 at Lone Pine Time Trials. I got a good 11k miles out of them with autox and canyon driving out of them. Replaced it with Nitto NT01 245/40. Looks pretty meaty __________________ addictedcollectibles.r/My IG '86 E30 (Project) 'VARIS Widebody http://www.ft86club.com/forums/showthread.php?t=103676

06-09-2016, 01:46 AM	#20
DHitHim Senior Member Join Date: Feb 2015 Drives: 2015 CWP Limited BRZ Location: Clovis, California Posts: 200 Thanks: 68 Thanked 46 Times in 38 Posts Mentioned: 1 Post(s) Tagged: 0 Thread(s)	Picked up new wheels to daily/autox/track (LOL I don't daily this car though). Didn't want to roll around on NT01s Wedsport 17x9 TC105N on 255/40 Rivals This past weekend I did 2 days at Buttonwillow Ran stock tire since I am new. I'd rather lose traction at low speed than at a higher speed with stickier tire. May 27th I also installed my Greddy Oil Cooler which I totally fucked up by not tightening the sandwich plate all the way. I bukake'd my engine bay with oil on a test drive for leaks. That was a pain to clean too. __________________ addictedcollectibles.r/My IG '86 E30 (Project) 'VARIS Widebody http://www.ft86club.com/forums/showthread.php?t=103676

06-16-2016, 01:30 PM	#21
DHitHim Senior Member Join Date: Feb 2015 Drives: 2015 CWP Limited BRZ Location: Clovis, California Posts: 200 Thanks: 68 Thanked 46 Times in 38 Posts Mentioned: 1 Post(s) Tagged: 0 Thread(s)	Picked up a Tommy Kaira/Rowen exhaust. This thing is beautiful! Love the way it sounds! __________________ addictedcollectibles.r/My IG '86 E30 (Project) 'VARIS Widebody http://www.ft86club.com/forums/showthread.php?t=103676

06-17-2016, 11:44 PM	#23
DHitHim Senior Member Join Date: Feb 2015 Drives: 2015 CWP Limited BRZ Location: Clovis, California Posts: 200 Thanks: 68 Thanked 46 Times in 38 Posts Mentioned: 1 Post(s) Tagged: 0 Thread(s)	Installed my Radium dual catch can kit today. __________________ addictedcollectibles.r/My IG '86 E30 (Project) 'VARIS Widebody http://www.ft86club.com/forums/showthread.php?t=103676

06-19-2016, 02:46 AM	#24
DHitHim Senior Member Join Date: Feb 2015 Drives: 2015 CWP Limited BRZ Location: Clovis, California Posts: 200 Thanks: 68 Thanked 46 Times in 38 Posts Mentioned: 1 Post(s) Tagged: 0 Thread(s)	Installed my whiteline rear crossmember bushings earlier tonight. Will see how it is tomorrow at autox! __________________ addictedcollectibles.r/My IG '86 E30 (Project) 'VARIS Widebody http://www.ft86club.com/forums/showthread.php?t=103676

07-28-2016, 04:16 AM	#26
DHitHim Senior Member Join Date: Feb 2015 Drives: 2015 CWP Limited BRZ Location: Clovis, California Posts: 200 Thanks: 68 Thanked 46 Times in 38 Posts Mentioned: 1 Post(s) Tagged: 0 Thread(s)	Took the car to Streets of Willow in CCW configuration earlier this month. [ame="https://www.youtube.com/watch?v=07zh9MXiG5w"]https://www.youtube.com/watch?v=07zh9MXiG5w[/ame] here's some photos. Then this past weekend went to Bass Lake with my @clint_111 to take our dogs to the lake. __________________ addictedcollectibles.r/My IG '86 E30 (Project) 'VARIS Widebody http://www.ft86club.com/forums/showthread.php?t=103676

08-31-2016, 04:16 AM	#27
DHitHim Senior Member Join Date: Feb 2015 Drives: 2015 CWP Limited BRZ Location: Clovis, California Posts: 200 Thanks: 68 Thanked 46 Times in 38 Posts Mentioned: 1 Post(s) Tagged: 0 Thread(s)	__________________ addictedcollectibles.r/My IG '86 E30 (Project) 'VARIS Widebody http://www.ft86club.com/forums/showthread.php?t=103676

09-30-2016, 02:18 AM	#28
DHitHim Senior Member Join Date: Feb 2015 Drives: 2015 CWP Limited BRZ Location: Clovis, California Posts: 200 Thanks: 68 Thanked 46 Times in 38 Posts Mentioned: 1 Post(s) Tagged: 0 Thread(s)	Well here's a huge update. I installed an FBM GT2871R kit. Reflect A Gold the Oil Pan __________________ addictedcollectibles.r/My IG '86 E30 (Project) 'VARIS Widebody http://www.ft86club.com/forums/showthread.php?t=103676

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
86EXPO 2015 Beers & Boxers August 14th, 2015	Events@Ptuning	Mid-Atlantic	24	07-26-2016 11:18 AM
2015 wrx vs 2015 gti vs ford focus st best all around dd and autocross	jflogerzi	Other Vehicles & General Automotive Discussions	13	05-25-2015 08:33 PM
2015 Formula Drift Tech Day - 3/28/2015	yospeed	Southern California	1	03-05-2015 03:10 PM
Aside from 2015 Acura NSX and Toyota Supra, what else in 2015?	stockysnail	Northwest	7	01-13-2015 02:30 AM
Nissan to enter 2015 24 Hours of Le Mans + 2015 FIA WEC	mav1178	Other Vehicles & General Automotive Discussions	1	05-23-2014 10:47 PM

User Name		Remember Me?
Password