|
DIY (Do-It-Yourself) Guides For all DIYs. |
|
Thread Tools | Search this Thread |
08-19-2013, 07:32 PM | #1 |
Chronic Flashturbator
Join Date: Sep 2012
Drives: '13 Scion FR-S MT
Location: Texas
Posts: 319
Thanks: 202
Thanked 98 Times in 55 Posts
Mentioned: 10 Post(s)
Tagged: 0 Thread(s)
|
Redneck steering wheel emblem swap
Just experimented a little and found a route that some of you may also want to go for the steering wheel emblem. I found this emblem here: http://www.ebay.com/itm/271255438906...84.m1497.l2649
Manufacturer part number: 305313710 I got lucky and my emblem was perfect. They are used and some may be scratched. In that case, I would just plasti-dip.. polish it or something. The emblem has tabs on the back that need to be pulled off and then sanded down. Before beginning, find and remove the two 7.5amp horn fuses so you don't scare yourself while you're working. There is a diagram on the bottom of the fusebox cover. Step 1: Carefully pry off the Scion emblem. Step 2: Use a pair of wire snips and maybe a razor blade to remove the raised Scion emblem mold in the middle of the steering wheel. If you don't remove it, the new emblem will not go flush against the steering wheel. Step 3: Use rough sandpaper (120-220 grit) and try to get the plastic center of the steering wheel as flat as possible... Some have got the middle of the steering wheel to a mirror shine using 2000 grit if I remember correctly. I just gave up on getting it perfect and went this route: I cut out an oval from a box of laminated red Mother's car wax and glued it behind the emblem using hot glue. Step 4: I secured my emblem into place using hot glue, which is great because it's easily reversible if you mess up or decide you don't like it. Step 5: Enjoy your custom emblem install
__________________
OFT Stg 2 UEL E85 - Borla UEL Header - Invidia Q300 - Invidia catless frontpipe - Fa20club CAI - Billet Power Blocks - Michelin PSS 245/35/18 all around on Motegi Racing SP10 18x8 +38 - Eibach Sportline springs - SPC LCA
Last edited by BuBlake; 08-20-2013 at 02:26 PM. Reason: adding photos |
08-20-2013, 12:32 AM | #2 |
Master Installer
Join Date: Apr 2013
Drives: Scion FRS
Location: Orange County, CA
Posts: 216
Thanks: 4
Thanked 144 Times in 57 Posts
Mentioned: 3 Post(s)
Tagged: 0 Thread(s)
|
Nice! I might try this out when I swap the outside emblems!
I think a matte black emblem on the airbag would look better. |
08-20-2013, 12:44 AM | #3 |
Senior Member
Join Date: Aug 2012
Drives: Toyota GT86, 66 beetle, 11 GSXR 750
Location: Las Vegas, NV.
Posts: 1,382
Thanks: 575
Thanked 836 Times in 436 Posts
Mentioned: 32 Post(s)
Tagged: 0 Thread(s)
|
Ordered mine up.. Thanks.. I've been putting off rebadging for some time now
|
08-20-2013, 06:14 AM | #4 |
Member
Join Date: Mar 2013
Drives: 2013 Ultramarine FR-S 6MT
Location: Ohio
Posts: 90
Thanks: 10
Thanked 21 Times in 10 Posts
Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
|
Ordered my emblem, looks like a fairly painless method. Thanks!
__________________
2013 Ultramarine FR-S (MT) |
08-20-2013, 01:02 PM | #5 |
Senior Member
Join Date: Aug 2012
Drives: FRS/NA1/'12 Mustang/'97 4Runner
Location: Kyle, TX
Posts: 249
Thanks: 230
Thanked 85 Times in 66 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
Interesting... This is the one eyesore that I've been wanting to fix. I noticed you're in Texas, how's the glue holding the emblem to the wheel holding up to the heat?
__________________
|
08-20-2013, 02:32 PM | #6 | |
Chronic Flashturbator
Join Date: Sep 2012
Drives: '13 Scion FR-S MT
Location: Texas
Posts: 319
Thanks: 202
Thanked 98 Times in 55 Posts
Mentioned: 10 Post(s)
Tagged: 0 Thread(s)
|
Quote:
I gave it a little pry on the edge and it seems to still be lodged in there pretty good. It hasn't had to sit in a parking lot yet, just the garage, but I'll let you know.
__________________
OFT Stg 2 UEL E85 - Borla UEL Header - Invidia Q300 - Invidia catless frontpipe - Fa20club CAI - Billet Power Blocks - Michelin PSS 245/35/18 all around on Motegi Racing SP10 18x8 +38 - Eibach Sportline springs - SPC LCA
|
|
08-20-2013, 06:20 PM | #7 |
Senior Member
Join Date: Apr 2013
Drives: 13 Whiteout 6MT
Location: Raleigh, NC
Posts: 246
Thanks: 104
Thanked 65 Times in 51 Posts
Mentioned: 2 Post(s)
Tagged: 0 Thread(s)
|
Been putting off doing this, but after pulling the airbag to swap colors on my interior trim, this looks super easy.
With the link, it looks even easier! Thanks, just ordered! |
08-21-2013, 12:12 AM | #8 |
Member
Join Date: May 2013
Drives: 86 Raven
Location: Liberty, TX
Posts: 51
Thanks: 25
Thanked 3 Times in 3 Posts
Mentioned: 2 Post(s)
Tagged: 0 Thread(s)
|
this is easier. did you remove the airbags or just the fuse of the horn?
|
08-21-2013, 06:47 AM | #9 |
Chronic Flashturbator
Join Date: Sep 2012
Drives: '13 Scion FR-S MT
Location: Texas
Posts: 319
Thanks: 202
Thanked 98 Times in 55 Posts
Mentioned: 10 Post(s)
Tagged: 0 Thread(s)
|
Just the two 7.5a horn fuses. There's a nifty little plastic tool built into the fuse box to help remove and re-install them as well.
__________________
OFT Stg 2 UEL E85 - Borla UEL Header - Invidia Q300 - Invidia catless frontpipe - Fa20club CAI - Billet Power Blocks - Michelin PSS 245/35/18 all around on Motegi Racing SP10 18x8 +38 - Eibach Sportline springs - SPC LCA
|
08-21-2013, 09:33 AM | #10 |
Junior Member
Join Date: Aug 2013
Drives: N/A
Location: Miami, FL
Posts: 4
Thanks: 0
Thanked 6 Times in 1 Post
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
Hey guys, my name is Justin from Ely's Tires. Thanks for linking to our listing. If you have any questions about the emblem, would like some more pictures, or are interested in anything else we have that you might like, just let me know.
As a thank you, I set up a discount code to use on our website (since eBay doesn't take discount codes). It's 5% off anything you order. Just enter ft86club when you're checking out. Here's the emblem on our site: https://elystires.com/shop/emblems/t...-logo-46720544 Feel free to ask any questions! Thanks, Justin @ Ely's Last edited by elystires; 12-08-2018 at 02:34 PM. Reason: Changed the URL... again! |
08-22-2013, 10:58 AM | #11 | |
Senior Member
Join Date: Jul 2012
Drives: .
Location: .
Posts: 333
Thanks: 176
Thanked 118 Times in 80 Posts
Mentioned: 6 Post(s)
Tagged: 0 Thread(s)
|
Quote:
|
|
08-22-2013, 11:22 AM | #12 |
Junior Member
Join Date: Aug 2013
Drives: N/A
Location: Miami, FL
Posts: 4
Thanks: 0
Thanked 6 Times in 1 Post
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
|
08-22-2013, 01:05 PM | #13 |
Senior Member
Join Date: Jul 2012
Drives: .
Location: .
Posts: 333
Thanks: 176
Thanked 118 Times in 80 Posts
Mentioned: 6 Post(s)
Tagged: 0 Thread(s)
|
|
08-22-2013, 01:53 PM | #14 |
Saving them pennies...
Join Date: Apr 2012
Drives: 2013 FR-S
Location: Miami, FL
Posts: 641
Thanks: 44
Thanked 178 Times in 111 Posts
Mentioned: 17 Post(s)
Tagged: 3 Thread(s)
|
Ohh damn someone is gonna get banned for not having a vendor account lol
|
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
WTB: Stock steering wheel (wheel not airbag) | mobybrz | Interior Parts (Incl. Lighting) | 2 | 09-11-2014 02:23 PM |
Steering wheel swap questions | firl21 | Cosmetic Modification (Interior/Exterior/Lighting) | 8 | 08-02-2014 08:27 PM |
scion frs steering wheel air bag and steering wheel | Jhon19lopez | Interior Parts (Incl. Lighting) | 7 | 01-04-2014 06:04 PM |
Would it be easy to swap the front of my steering wheel? | bdanisi | Scion FR-S / Toyota 86 GT86 General Forum | 9 | 05-11-2013 03:34 PM |
Swap your Scion key emblem for a Toyota | Synack | Scion FR-S / Toyota 86 GT86 General Forum | 6 | 08-03-2012 05:58 PM |