|
Suspension | Chassis | Brakes -- Sponsored by 949 Racing Relating to suspension, chassis, and brakes. Sponsored by 949 Racing. |
|
Thread Tools | Search this Thread |
09-14-2015, 01:43 PM | #1 |
Member
Join Date: Aug 2015
Drives: 2015 BRZ
Location: Mechanicsville VA
Posts: 25
Thanks: 4
Thanked 6 Times in 3 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
Skunk2 Pro-C Coilovers
Just purchased and installed a new set of PRO-C's.
Set the rear ride hight and pre-load the exact same for both the right and left side of the car. After putting the car back down on all 4 tires and leaving over night, I find the next day that the vehicle has settled 1/4 of an inch more on the drivers side than the passengers side. My question is towards the design of the vehicle. To get the proper cross weight, did Toyota/Subaru adjust the suspension geometry to compensate for the driver? meaning I need to actually add more ride hight to the Drivers side and increase the preload? The front's came out perfectly and did not settle at all. exact same length fender to floor. I just dont understand how I could have a 1/4" difference with both coilovers in the rear having equal configurations. Thanks for any assistance you can provide. |
09-14-2015, 01:51 PM | #2 | |
Senior Member
Join Date: Jun 2014
Drives: '13 10 Series FRS #1203
Location: Albany, NY
Posts: 850
Thanks: 7
Thanked 385 Times in 220 Posts
Mentioned: 5 Post(s)
Tagged: 0 Thread(s)
|
Quote:
|
|
09-14-2015, 02:10 PM | #3 |
Member
Join Date: Aug 2015
Drives: 2015 BRZ
Location: Mechanicsville VA
Posts: 25
Thanks: 4
Thanked 6 Times in 3 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
TY,
The car is new. Was looking to get a little lower and have the ability to manipulate dampening. I will pull her apart again this evening. 8) |
|
|
Thread Tools | Search this Thread |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Skunk2 Header? | FirestormFRS | Engine, Exhaust, Transmission | 69 | 10-11-2019 09:42 AM |
Skunk2 Pro-C Coilovers for FRS, BRZ, FT86 | KraftWerks | Suspension | Chassis | Brakes -- Sponsored by 949 Racing | 27 | 06-04-2015 04:06 PM |
Skunk2 Radiator DIY | post_break | DIY (Do-It-Yourself) Guides | 5 | 03-20-2015 08:47 AM |
Skunk2 Review. | FirestormFRS | Engine, Exhaust, Transmission | 1 | 12-31-2014 08:55 PM |
Skunk2 Pro C Coilovers in stock and Ready to ship! | rickspecd | Suspension | Chassis | Brakes -- Sponsored by 949 Racing | 2 | 09-10-2014 01:21 PM |