04-02-2014, 12:10 PM | #127 | |
Senior Member
Join Date: Jun 2012
Drives: 2013 Subaru BRZ
Location: NOVA
Posts: 894
Thanks: 227
Thanked 343 Times in 202 Posts
Mentioned: 8 Post(s)
Tagged: 1 Thread(s)
|
Quote:
__________________
Build Thread:
http://www.ft86club.com/forums/showthread.php?t=43355 |
|
04-02-2014, 12:11 PM | #128 | |
Senior Member
Join Date: Jun 2012
Drives: 2013 Subaru BRZ
Location: NOVA
Posts: 894
Thanks: 227
Thanked 343 Times in 202 Posts
Mentioned: 8 Post(s)
Tagged: 1 Thread(s)
|
Quote:
__________________
Build Thread:
http://www.ft86club.com/forums/showthread.php?t=43355 |
|
The Following User Says Thank You to Flat Black VW For This Useful Post: | zc06_kisstherain (04-02-2014) |
05-24-2014, 03:54 AM | #129 |
Senior Member
Join Date: Apr 2013
Drives: GTS 86 auto
Location: Australia
Posts: 486
Thanks: 263
Thanked 127 Times in 99 Posts
Mentioned: 3 Post(s)
Tagged: 0 Thread(s)
|
People,
Do you have a way to save your head unit settings in order to restore after disconnecting power? Fujitsu TEN head unit.
__________________
GTS86 Auto (Australia)
|
05-28-2014, 03:38 AM | #130 |
Senior Member
Join Date: Apr 2013
Drives: GTS 86 auto
Location: Australia
Posts: 486
Thanks: 263
Thanked 127 Times in 99 Posts
Mentioned: 3 Post(s)
Tagged: 0 Thread(s)
|
A good camera mounting position that is only about 35mm off center can be made under the badge by filling and levelling the surface with epoxy putty or similar. Test with BluTac beforehand.
__________________
GTS86 Auto (Australia)
|
05-29-2014, 09:23 PM | #131 | |
Senior Member
Join Date: May 2014
Drives: 2014 BRZ MT (Sold); 2006 V70R
Location: Fairfax
Posts: 873
Thanks: 10
Thanked 186 Times in 150 Posts
Mentioned: 8 Post(s)
Tagged: 0 Thread(s)
|
Quote:
===========UPDATE============ For newer units, it seems like the new firmware has fixed the bypass trick. I don't have a shot of my current firmware, but I bypassed the VSS, which enables video playback only until GPS get a lock. Once GPS gets a signal lock, video playback is disabled again (blue screen with sound only). The new firmware must be using the GPS speed to trigger the lockout. =( |
|
08-17-2014, 07:39 PM | #132 |
Senior Member
Join Date: Apr 2013
Drives: GTS 86 auto
Location: Australia
Posts: 486
Thanks: 263
Thanked 127 Times in 99 Posts
Mentioned: 3 Post(s)
Tagged: 0 Thread(s)
|
Instead of using the grommet to route the wire you can pop one of the light housings out and route through the hole, then put the light back. The light housing has a foam dust seal that is thick enough to absorb the wire.
__________________
GTS86 Auto (Australia)
|
11-14-2014, 06:31 AM | #133 |
Senior Member
Join Date: Nov 2013
Drives: gt86
Location: spain
Posts: 231
Thanks: 0
Thanked 7 Times in 7 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
as we would do to have front and back camera?
|
11-14-2014, 04:27 PM | #134 |
Senior Member
Join Date: Apr 2013
Drives: GTS 86 auto
Location: Australia
Posts: 486
Thanks: 263
Thanked 127 Times in 99 Posts
Mentioned: 3 Post(s)
Tagged: 0 Thread(s)
|
Sorry, I don't understand the question. Wiring under the foam is just for the installation of a rear camera.
__________________
GTS86 Auto (Australia)
|
11-16-2014, 09:26 AM | #135 |
Member
Join Date: Feb 2014
Drives: 2014 Scion FRS 10 Series
Location: Tampa, FL
Posts: 29
Thanks: 11
Thanked 19 Times in 11 Posts
Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
|
If anyone was looking for a backup camera that does not require drilling holes or "mod"
http://www.ebay.com/itm/Brand-New-Ca...-/141314675831 Just found it while I was looking for an easy to install backup camera
__________________
2014 Sc10n FRS 10-Series #655 of 2500 |
The Following User Says Thank You to MasterMech77 For This Useful Post: | notout86 (11-16-2014) |
11-16-2014, 09:46 AM | #136 |
Senior Member
Join Date: Nov 2013
Drives: gt86
Location: spain
Posts: 231
Thanks: 0
Thanked 7 Times in 7 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
It looks great this camera!
My last question relates to install a camera at the back and one on the front of the car. |
11-16-2014, 05:03 PM | #137 | |
Senior Member
Join Date: Apr 2013
Drives: GTS 86 auto
Location: Australia
Posts: 486
Thanks: 263
Thanked 127 Times in 99 Posts
Mentioned: 3 Post(s)
Tagged: 0 Thread(s)
|
Quote:
Does it work off 6Volt too? That would mean convenience of integration with the Toyota86 head unit. Does it have a wire to cut to remove the guidelines? I am not clear from the pics but it looks as if the video cable does not go inside the light. I could be muddled about this as I have forgotten the exact setup within, but if it does then it may not be necessary to go through the grommet?
__________________
GTS86 Auto (Australia)
|
|
11-16-2014, 05:23 PM | #138 | |
SLO NO MO
Join Date: Jul 2012
Drives: '19 Tesla Model 3 Performance
Location: NY, USA
Posts: 2,961
Thanks: 224
Thanked 1,062 Times in 738 Posts
Mentioned: 34 Post(s)
Tagged: 0 Thread(s)
|
Quote:
Sent from my Nexus 5 using Tapatalk |
|
11-16-2014, 05:30 PM | #140 | |
SLO NO MO
Join Date: Jul 2012
Drives: '19 Tesla Model 3 Performance
Location: NY, USA
Posts: 2,961
Thanks: 224
Thanked 1,062 Times in 738 Posts
Mentioned: 34 Post(s)
Tagged: 0 Thread(s)
|
Quote:
Here's an example of the switch: http://www.aliexpress.com/item/front...675896600.html Sent from my Nexus 5 using Tapatalk |
|
|
|
Thread Tools | Search this Thread |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
DIY Nav unit in FRS with e-brake bypass and iPhone cable by cupholders | Nitro | DIY (Do-It-Yourself) Guides | 42 | 07-02-2016 11:10 AM |
Name that spoiler! (SOLVED) | WingsofWar | FR-S & 86 Photos, Videos, Wallpapers, Gallery Forum | 70 | 12-06-2014 01:22 PM |
BRZ NAV/DVD bypass | Scooby South | Electronics | Audio | NAV | Infotainment | 88 | 02-24-2014 03:41 PM |
how I solved my gilrfriend's problem with headrest angle | alexmotrix | Cosmetic Modification (Interior/Exterior/Lighting) | 8 | 08-08-2012 08:00 AM |
Drove the 86GT and NC miata back to back on GT5 | Hanzo | FR-S & 86 Photos, Videos, Wallpapers, Gallery Forum | 39 | 01-07-2012 12:56 PM |