WHAT DID YOU DO TO YOUR BRZ TODAY? - Page 1012 - Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community

Ethereal05 · 04-28-2016, 07:55 PM

Quote:

Originally Posted by BirdTRD

I didn't know you could get just that piece of the garnish. How much did it run you? If I decide to make it "permanent", I might just have to go that route.

Yea, I wanted to change them black before the Hyper.Blue was announced and I was happy to see I could purchase the OEM fins in black. Same here, but I saw a DIY on here that enlightened me that the chrome fins are held on by double-sided tape. They are $80 for the pair (link below), which was a little pricey but they look really clean and were easy to install once I got the other chrome fins off.

http://subaruonlineparts.com/subaru-...ck-p-4113.html

ichitaka05 · 04-29-2016, 12:27 PM

Finally installed hubcentric rings & swag came in

Sent from my iPhone using Tapatalk

kch · 04-29-2016, 01:05 PM

Quote:

Originally Posted by Porcupint

The A clips on both of mine finally snapped at the metal yesterday when trying to put them back in.... Not sure if I'm going to clear markers or just zip tie them.

I just put tiny strips of 3m double-sided tape on the top of the side marker. it's working well so far but i'm not sure how easily they'll come out

BirdTRD · 04-29-2016, 04:23 PM

Opened a box full of sexy!

SmartedPanda · 04-29-2016, 04:36 PM

Quote:

Originally Posted by kch

I just put tiny strips of 3m double-sided tape on the top of the side marker. it's working well so far but i'm not sure how easily they'll come out

Might steal this, mine gets loose every 2-3 weeks. Damn it Helix.

Porcupint · 04-29-2016, 11:53 PM

Quote:

Originally Posted by kch

I just put tiny strips of 3m double-sided tape on the top of the side marker. it's working well so far but i'm not sure how easily they'll come out

Quote:

Originally Posted by SmartedPanda

Might steal this, mine gets loose every 2-3 weeks. Damn it Helix.

I went the zip tie route. Pull the metal A clip out. Drill a small hole through where spot where the clip was. Put the marker on the car. Push a small zip tie through the hole where you press the clip down and through the hole you drilled in the marker and the zip tie should come back around to you. Zip it down and you're good to go.

Honestly it works quite well and much easier than dealing with those damn clips.

jasonojordan · 04-30-2016, 05:54 PM

Started out the day with win! Then went winless

. Then ended the day with win!!!!

(inside joke. On a local car forum a kid asked how to make his car winless. It was a typo and we ran with it)

BirdTRD · 04-30-2016, 06:12 PM

Got the light smoke Valenti Revo's installed yesterday. Lovin' the new look of the ass end. Waiting for a few more "accessories" to come in on Monday that should help change it up just a bit more.

SmartedPanda · 04-30-2016, 07:22 PM

Quote:

Originally Posted by jasonojordan

Started out the day with win! Then went winless

. Then ended the day with win!!!!

(inside joke. On a local car forum a kid asked how to make his car winless. It was a typo and we ran with it)

Did you follow this guide?
http://www.ft86club.com/forums/showt...18587:thumbup:

JPxM0Dz · 04-30-2016, 11:37 PM

trigun286 · 04-30-2016, 11:58 PM

Put in a factory order for a manual WRB Limited. 😀

Sent from my Nexus 9 using Tapatalk

Kiske · 05-01-2016, 02:59 AM

Officially got her diagnosed... RIP. Cylinder 3 direct injection seal failed, causing lean causing, making boost = bad time. Scouring for a replacement block. Sadly I was hoping to save up to build my stock block, I don't think I can financially swing buing a new engine and sending it to full blown to be built. Will just have to settle for getting it runing again.

Figures... I was just getting geared up to start my custom rear difuser project to match my front end.

DuMa · 05-01-2016, 01:17 PM

Today i turned into an FR-S

DSOmegaX · 05-01-2016, 02:30 PM

Put her in the shop for a few days for a complete rear subframe change out

Sent from my iPhone using Tapatalk

04-29-2016, 12:27 PM	#14156
ichitaka05 Site Moderator Join Date: Oct 2009 Drives: ichi 86 Project Location: Middle of No where Posts: 20,968 Thanks: 7,664 Thanked 19,057 Times in 8,329 Posts Mentioned: 678 Post(s) Tagged: 27 Thread(s)	Finally installed hubcentric rings & swag came in Sent from my iPhone using Tapatalk __________________

04-30-2016, 05:54 PM	#14161
jasonojordan Senior Member Join Date: Jul 2013 Drives: 2013 satin white brz limited Location: Cottage Grove MN Posts: 1,049 Thanks: 162 Thanked 511 Times in 326 Posts Mentioned: 4 Post(s) Tagged: 0 Thread(s)	Started out the day with win! Then went winless . Then ended the day with win!!!! (inside joke. On a local car forum a kid asked how to make his car winless. It was a typo and we ran with it) Attached Images

04-30-2016, 11:58 PM	#14165
trigun286 Member Join Date: Nov 2015 Drives: '16 WRB Limited Location: Raleigh/Charlotte Posts: 83 Thanks: 18 Thanked 37 Times in 23 Posts Mentioned: 1 Post(s) Tagged: 0 Thread(s)	Put in a factory order for a manual WRB Limited. 😀 Sent from my Nexus 9 using Tapatalk __________________

05-01-2016, 02:59 AM	#14166
Kiske Senior Member Join Date: Jun 2013 Drives: RX-7 / BRZ Location: USA Posts: 2,343 Thanks: 1,026 Thanked 2,501 Times in 1,081 Posts Mentioned: 27 Post(s) Tagged: 0 Thread(s)	Officially got her diagnosed... RIP. Cylinder 3 direct injection seal failed, causing lean causing, making boost = bad time. Scouring for a replacement block. Sadly I was hoping to save up to build my stock block, I don't think I can financially swing buing a new engine and sending it to full blown to be built. Will just have to settle for getting it runing again. Figures... I was just getting geared up to start my custom rear difuser project to match my front end. Attached Images __________________ //2013 World Rally Blue BRZ Limited FBM Turbo--gone //2018 Crystal White Pearl BRZ Ts 2.2l Harrop Supercharged

05-01-2016, 02:30 PM	#14168
DSOmegaX Senior Member Join Date: Jul 2012 Drives: '19 M2 Comp, '20 GR Supra Location: Irvine, CA Posts: 1,904 Thanks: 109 Thanked 2,153 Times in 986 Posts Mentioned: 51 Post(s) Tagged: 3 Thread(s)	Put her in the shop for a few days for a complete rear subframe change out Sent from my iPhone using Tapatalk __________________ @dsomegax.cars 2013 Subaru BRZ Limited \| WRB \| STI tS Build Thread [SOLD] 2019 BMW M2 Competition \| LBB \| ///M Performance Build Thread 2020 Toyota GR Supra \| Turbulence \| TRD \| Build Thread

05-01-2016, 01:17 PM	#14167
DuMa Senior Member Join Date: Nov 2011 Drives: LR BRZ Limited Location: PNW Posts: 904 Thanks: 199 Thanked 648 Times in 276 Posts Mentioned: 3 Post(s) Tagged: 1 Thread(s)	Today i turned into an FR-S

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Saw My First FR-S Today	Marrk	Scion FR-S / Toyota 86 GT86 General Forum	26	05-15-2013 12:40 PM
Got my new FR-S today.	Boosted2.0	Scion FR-S / Toyota 86 GT86 General Forum	51	06-03-2012 10:35 PM
Sat in a FRS today!!	Ladnerd	Scion FR-S / Toyota 86 GT86 General Forum	12	04-30-2012 01:48 PM
Got my VIN today...	Enemies	BRZ First-Gen (2012+) -- General Topics	63	04-12-2012 10:19 PM
sat in a BRZ today	NESW20	BRZ First-Gen (2012+) -- General Topics	8	03-31-2012 08:53 AM

User Name		Remember Me?
Password