Will this fit? (width, offset and tire size Qs)

[azynneo]

any options for running a 10width in the rear with a 265/35 meaty tire to prevent rubbing? I'm sitting at -2.3 rear camber and not even lowered that much but it's seeing rub at each and every small dip. Will running an after market LCA and more camber help out? Or am I looking at fender pull / widebody.

[HECK EM ALL]

.

[wally]

Any1 know if these wheels would fit on my GT86? Rota Grid 18x9.5 ET(23)

[krat0$]

Hi guys! I'm quite new on this one. I have a 2017 brz with the performance package and I'm planning to get a new set of wheels. Would a 17x8 +45 sit perfectly on my car with the stock suspension and wouldn't rub the brembo calipera and would it look better than the stock ones in terms of the aggressive look? TIA

[JBezugs]

Looking at these for a winter setup on my car, and wondering if these wheels will fit. They are 16x6.5 +55 JDM Legacy BBS Wheels.

[Devin11498]

I have a general idea when it comes to Tires and wheels but not enough to trust my judgment. My Brz suspension is currently stock. I do plan on getting coils before I get the wheels. I'm just curious as to if it will rub? What do yall think? Will I have any issues fitting these wheels on stock suspension? Would I need spacers possibly? I have no idea, thanks


Coils of choice - Tein Flex Z
Planned Setup

Wheel
Ambit RE02
18x9.5 +38

Tire
Federal RS-R 255/35/R18

[swarb]

Originally Posted by wally

Any1 know if these wheels would fit on my GT86? Rota Grid 18x9.5 ET(23)

It won't fit without 3-4++ camber all around and/or 225/40 tires or smaller. The offset for 9.5 is 35-38 up to 40(may need 2-3mm spacer up front)

[swarb]

Originally Posted by krat0$

Hi guys! I'm quite new on this one. I have a 2017 brz with the performance package and I'm planning to get a new set of wheels. Would a 17x8 +45 sit perfectly on my car with the stock suspension and wouldn't rub the brembo calipera and would it look better than the stock ones in terms of the aggressive look? TIA

Not all wheels are the same. The rpf1 17x8 +45 fits, but the +35 for example doesnt. You need to look for the PP wheel fitment thread.

[swarb]

Originally Posted by JBezugs

Looking at these for a winter setup on my car, and wondering if these wheels will fit. They are 16x6.5 +55 JDM Legacy BBS Wheels.

Yes those should be fine.

[swarb]

Originally Posted by Devin11498

I have a general idea when it comes to Tires and wheels but not enough to trust my judgment. My Brz suspension is currently stock. I do plan on getting coils before I get the wheels. I'm just curious as to if it will rub? What do yall think? Will I have any issues fitting these wheels on stock suspension? Would I need spacers possibly? I have no idea, thanks


Coils of choice - Tein Flex Z
Planned Setup

Wheel
Ambit RE02
18x9.5 +38

Tire
Federal RS-R 255/35/R18

Depends how low you are, the fronts should be ok, but the rears will be very close to the bumper tab and will probably rub a little. RSR's run wide. Also check out the newer RSRR. At full lock or if you are lower than 1.5 inches they will fit very tightly and may rub the side marker area.

[swarb]

Originally Posted by JBezugs

Looking at these for a winter setup on my car, and wondering if these wheels will fit. They are 16x6.5 +55 JDM Legacy BBS Wheels.

http://www.ft86club.com/forums/showthread.php?t=28174
+7mm offset difference in the thread above.
Outside wheel clearance should be fine. I only worry about caliper clearance, but I highly doubt you will have any problems.

[Devin11498]

Originally Posted by swarb

Depends how low you are, the fronts should be ok, but the rears will be very close to the bumper tab and will probably rub a little. RSR's run wide. Also check out the newer RSRR. At full lock or if you are lower than 1.5 inches they will fit very tightly and may rub the side marker area.

I don't know yet how low I might want to go. I'm not trying to get some stance but would like a low fitment. I also have the option of going with a 245/40/R18 instead of the 255/35/R18. As mush as I would like to run a 255 I wouldn't mind a 245. Anything is better than the stock tires lol. Do you think the 245 would be good enough to where I wouldn't have to worry about any rubbing what so ever?

[swarb]

Originally Posted by Devin11498

I don't know yet how low I might want to go. I'm not trying to get some stance but would like a low fitment. I also have the option of going with a 245/40/R18 instead of the 255/35/R18. As mush as I would like to run a 255 I wouldn't mind a 245. Anything is better than the stock tires lol. Do you think the 245 would be good enough to where I wouldn't have to worry about any rubbing what so ever?

245/40 is too tall, you will rub more. 245/35 is closest to stock size.

[krat0$]

Originally Posted by swarb

Not all wheels are the same. The rpf1 17x8 +45 fits, but the +35 for example doesnt. You need to look for the PP wheel fitment thread.

Thanks!