LED lighting upgrade and Flasher Relay.

[zooplane]

Originally Posted by abutterman

i got it out with a good pull... only problem is i had 2 things in my hand. The flasher and a whole lot of blood. looked like i just punched some bricks. I cant seem to get the clip out of the original one though to put on the new one

HOW!?!?! Which way do I pull is there a clip?? I don't want to break anything!!

THANKS!

[abutterman]

Originally Posted by zooplane

HOW!?!?! Which way do I pull is there a clip?? I don't want to break anything!!

THANKS!

yea it's a pretty stubborn clip. I just twisted and pulled until it finally popped out from where it was which resulted in my hand jolting downwards and cutting open on something up in there. I'm still trying to get the damn clip out of the original flasher though to put in the new one. It looks like it just slides out of where it's attached but it's in there pretty good.

[JWMotoring]

Originally Posted by 86 FRS

i never had those long initial flash. i bought my relay from JWMotoring. LED from automationLED.

Thanks! We have these units in stock

[zooplane]

Does anyone have those little white clips that hold the flasher in place!?

[husker741]

Originally Posted by abutterman

I cut my knuckles up pretty good this morning installing mine lol. Do your flashers cause the first flash of the signal to stay on slightly longer than the following flashes? When i turn the signal on, the first flash stays lit for around 1 full second and every flash after that is the normal half second or so.

Originally Posted by Trashed675

I noticed that as well, anybody else?

Originally Posted by Iddoit2er

Ive noticed this, but i dont think its terrible. Also, good luck getting the factory relay out. It took me a real long time to get out, even after taking all of the panels off to get a clear shot at it. I totally shredded the white clip that the relay sits in...but i did get it out and put the LED relay in its place

Originally Posted by abutterman

i guess that longer initial flash might be normal. I just emailed diode dynamics to see if it's supposed to do that

Anyone ever figure this out? I too got mine from JWMotoring, but I have that longer initial flash and it's bugging me.

[sid325]

Get this: http://www.ft86club.com/forums/showthread.php?t=33477

Problem solved. The delay bugged the crap out of me too and the tap-turn fixed it and the other features are nice.

Jacob

[makalaka]

Originally Posted by Iddoit2er

Ive noticed this, but i dont think its terrible. Also, good luck getting the factory relay out. It took me a real long time to get out, even after taking all of the panels off to get a clear shot at it. I totally shredded the white clip that the relay sits in...but i did get it out and put the LED relay in its place

Originally Posted by zooplane

Does anyone have those little white clips that hold the flasher in place!?

In case anyone needs a new white clip.

Toyota Part:
Wiring Harness Clamp
82711-1E320