|
Off-Topic Lounge [WARNING: NO POLITICS] For all off-topic discussion topics. |
|
Thread Tools | Search this Thread |
05-15-2010, 12:07 AM | #1 |
Golden sword
Join Date: May 2010
Drives: what is the Car?
Location: HK
Posts: 9
Thanks: 0
Thanked 0 Times in 0 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
HG 1:144 Kyrios(tt hongli) review...
Since I never really did a review on a Kyrios, here's a brief on it; Kyrios is Celestial Being's 3rd Gundam mobile suit and is piloted by Allelujah Haptism, a super soldier. It is the only transformable MS they have on board the Ptolemy(sp?). While in flight mode, it normally shoots out bombs(or something close to that). GN-003 - Gundam Kyrios Pilot: Allelujah Haptism Height: 18.9m Weight: 54.8t Armaments: GN Beam Sub-Machinegun GN Beam Saber(2) GN Shield Tail Part(bomb storage?) Part 1: Box Part 2: Box Open! Part 3: Runners Runners are quite satisfactory. At least the GN Cables are in the right shade of purple and the stickers are almost color correct plus they can stick. Part 4: Manual Scans Okay, manual scans are now here! Sorry that the scans aren't big and clear enough to be easily read. ^^; Part 5: Building & Notes Part 5.1: First Step I just couldn't stop myself from doing this. I really do like the GN Condensers to be green in color. XP Part 5.2: Torso Not building problems here. Everything "fits" rather well, though not completely, as you can see from the side view. Part 5.3: Head Looks good, right? Not so as before I had to carve the left part of the helmet covering the eyes. At first, I thought it was a sticker problem until I stared at the head long enough for me to find out the left side of the helmet wasn't molded properly. Pfft. Oh well, at least with a bit of carving, it looks better... though would had been much better if the sticker didn't wear out from me trying to place it "properly" beforehand. =/ This problem might not affect all the TT HG Kyrios kits though, I was probably just unlucky on this one, hopefully. Furthermore, the V-Fin doesn't like to stay on properly and likes to fall down with a bit of pressure on it. Part 5.4: Arms For the arms, they do look okay, but not so very much. One of the GN Condenser clear piece didn't fit in properly. I had to put some superglue on it for it to stick onto the arm. It isn't so major and might not happen to everyone though. However, the thing that really can get annoying is that the GN Cables(light purple rubber part at the elbow connection) might not go in properly when you straighten back the arm from a bending position as it does not seem to slide in very well. I think if you carve a bit inside the arm, this problem can go away though. You can also "hold" onto the cable everytime you straighten back the arm as this works too. Then again, annoying. =/
__________________
|
05-15-2010, 12:09 AM | #2 |
Golden sword
Join Date: May 2010
Drives: what is the Car?
Location: HK
Posts: 9
Thanks: 0
Thanked 0 Times in 0 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
Part 5.5: Legs
There seems to be nothing wrong with the legs. =D Part 5.6: Waist Waist is totally fine. If you look closely, the beam sabers are mounted onto the rear skirts. Part 5.7: Armaments The shield is quite okay but if you force it a little bit, it might open up into pieces(doesn't break). Part 6: Kyrios Allelujah: "I have control." "Get away from my bottle of water, you *******s!" Part 6.1: Up, Left, Back, Right! The plastic looks a bit cheap, but you can't do much to prevent that if you're buying bootlegs. XP Part 6.2: Articulation & Gimmicks Arms can go really high thanks to its transformation ability. =) Legs can go pretty high up but gets blocked by the front skirt. *pew**pew**pew* in rapid succession! >D Two ways you can equip the beam sub-machinegun. The arm mounted way is for when in flight mode though. Then again, the weapon tilts down a bit when held in the hand... no matter how it is held, it can easily fall off sadly. Hallelujah: "Isn't this fun?! RIGHT ALLELUJAH?!" The shield is not so bad though can fall off the arms quite easily like the original FG Kyrios... Don't fret though, the claw works quite well. =P Part 6.3: Transformation First, take off the legs. Taking off the weapons helps to maintain your blood pressure. They just won't stick onto the Kyrios well enough! D= Also, take off the cover of the hole to connect to an action base under the Kyrios. I didn't really put it on in the first place. Take off the black part on top of the legs and replace them with this one singular "V" shaped piece. Hopefully you can tell from these two photos. I'm to lazy to explain this part in words. XP Now, onto the top part of the Kyrios. Open up the backpack. Make sure the "ponytail" of the Kyrios slots into the hole as seen above. Move the arms down and bend them a little, the orange parts are straightened and pull out the two clavicles near the "cockpit". Looks quite nice for a bootleg, ne? =) At any rate, Kyrios just looks wrong when you look from underneath...
__________________
|
05-15-2010, 12:10 AM | #3 |
Golden sword
Join Date: May 2010
Drives: what is the Car?
Location: HK
Posts: 9
Thanks: 0
Thanked 0 Times in 0 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
Part 6.4: Comparison
The biggest seeable difference is te color scheme... XD I don't have the original Kyrios, but I do have the Trans-AM version. I just couldn't get the original one as I guess it has been in the market for quitea while already. XP If you can tell, the Trans-AM version is more sharper looking than the bootleg. It also don't really drop its weapons as bad. But for some reason, the right arm likes to sag down... =/ Part 7: Conclusion HG Kyrios As A Whole The HG Kyrios was infamous for one problem, the "backpack". The design of the back of the Kyrios caused the HG kit to be a bit back heavy and can easily tumble off its feet. This is also contributed to its rather small feet design. If you already own a HG Kyrios, you'll understand what I mean. A stand is quite necessary for this model if you want it to stay ina dynamic pose. =) The Bootleg Pros # The main body is very sturdy! # It can transform well unlike the TT HG Union Flag. # Very close to the original. # Fair price Cons * V-Fin and armaments likes to drop down easily. * Some parts had molding errors (helmet and arm). * Seam lines are very obvious. All in all, the model kit isn't so bad. Well, the armaments are a bit lose on this guy but at least they can still stick on! XP Well, if you're in for a Kyrios model kit and do not have the original or have no chance of buying the original, this kit gets my approval for purchase. =)
__________________
|
05-15-2010, 11:11 AM | #4 |
Turtle Factory
Join Date: Oct 2009
Drives: Mint M3
Location: PDX
Posts: 1,286
Thanks: 1,021
Thanked 613 Times in 312 Posts
Mentioned: 9 Post(s)
Tagged: 1 Thread(s)
|
You are doing Gundam Model Reviews and building in 1:144 scale? Come on you have to step up to the big league buddy!
Here are a couple of mine. I have about 150 Gundams at my parents house. Once my house is done I will be able to display all my toys! |
05-15-2010, 09:36 PM | #5 |
Elite Padawan
Join Date: Mar 2010
Drives: '15 WRX, 15 GLA250, and 2 feet
Location: Shoreline, WA
Posts: 3,498
Thanks: 197
Thanked 250 Times in 159 Posts
Mentioned: 8 Post(s)
Tagged: 0 Thread(s)
|
Dammit. I got 5. all are 1 100.
|
05-16-2010, 09:27 PM | #6 |
Golden sword
Join Date: May 2010
Drives: what is the Car?
Location: HK
Posts: 9
Thanks: 0
Thanked 0 Times in 0 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
Well , Actually I have 1:100 kits too , I just want to know if there are some body likes the review. If you do , I could post more.
__________________
|
05-17-2010, 12:20 AM | #7 |
Elite Padawan
Join Date: Mar 2010
Drives: '15 WRX, 15 GLA250, and 2 feet
Location: Shoreline, WA
Posts: 3,498
Thanks: 197
Thanked 250 Times in 159 Posts
Mentioned: 8 Post(s)
Tagged: 0 Thread(s)
|
It's good tho because I dunno how to write up a review.
I dun have any season1 Gundam 00 Gundam except Exia. I have all season 2 Gundam 00 Celestial Being tho. |
05-17-2010, 02:46 AM | #8 | |
Golden sword
Join Date: May 2010
Drives: what is the Car?
Location: HK
Posts: 9
Thanks: 0
Thanked 0 Times in 0 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
Quote:
come on ,I want to see what you've got.
__________________
|
|
05-17-2010, 03:46 PM | #9 |
Turtle Factory
Join Date: Oct 2009
Drives: Mint M3
Location: PDX
Posts: 1,286
Thanks: 1,021
Thanked 613 Times in 312 Posts
Mentioned: 9 Post(s)
Tagged: 1 Thread(s)
|
I ll write up the next master grade I build! If u want?
|
05-17-2010, 09:48 PM | #10 |
Golden sword
Join Date: May 2010
Drives: what is the Car?
Location: HK
Posts: 9
Thanks: 0
Thanked 0 Times in 0 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
yeah, share with us..
__________________
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Review: 2010 Kia Forte Koup SX a beauty queen that can't hide its roots | vh_supra26 | Other Vehicles & General Automotive Discussions | 4 | 02-18-2010 08:53 AM |