Audio Directory

[brianlo622]

Originally Posted by rupert

Thanks! I have added you to the list

Thanks!!!

[zohare]

Originally Posted by rupert

General Information

Speaker Sizes

• Tweeter: 1"
• Midrange: 3.5" (Depth: 2")
• Woofer - 6.5" (Depth: 2" without spacers)
• Rear - 3.5" (Depth: omgwtfbbq a.k.a. enough)

Thank you!
Can I note- The wiring diagram says 6.3" for OEM doors ;P not that it matters.
Also, in the diagram, I'm noting that basically, (off the amp at least,) the front speakers are all wired together, so if I do a 4 CH amp I'm good right?

[oldpueblo]

Somewhere is a post where someone removed the stock speakers and took pictures of the specs on back. Can anyone find that post and add it to this list? So far I am unsuccessful.

[rupert]

My stock speakers are somewhere since I have done my install. I can look tonight for them and see if I can get any good information off of them.

[oldpueblo]

Thanks. I'm actually happy with the stock system and will just be adding a powered subwoofer. I'm interested to see what frequencies might be best left to the stock system and where I should cross over the sub. I think the stock 6.5 subs actually do decent mid-bass already.


Also if I decide to replace stock speakers, knowing what their specs are will make it easier to buy better ones.

[scott86]

Hi all

First post on here so i hope it goes into the right place!
OK so how about the Australian 86 doesn't have a spare wheel (Bit odd I thought!) but it all made sense when I custom molded a fibreglass sub enclosure into it - including a 700rms JL Audio 5 channel amp with Morel 200rms front splits on custom spacers in the front and a single din Alpine head unit
Leads for power and speakers are Stinger and cabled on opposite sides of the car to reduce/eliminate interference

Some photos to follow - but sound is incredible and sub though only a 8 inch proves more than enough thump

Cheers Scott

[rupert]

Originally Posted by scott86

Hi all

First post on here so i hope it goes into the right place!
OK so how about the Australian 86 doesn't have a spare wheel (Bit odd I thought!) but it all made sense when I custom molded a fibreglass sub enclosure into it - including a 700rms JL Audio 5 channel amp with Morel 200rms front splits on custom spacers in the front and a single din Alpine head unit
Leads for power and speakers are Stinger and cabled on opposite sides of the car to reduce/eliminate interference

Some photos to follow - but sound is incredible and sub though only a 8 inch proves more than enough thump

Cheers Scott

Hey Scott! Sounds like you have a nice setup. If you want, post a new thread that shows it off. I would be happy to link to it and make sure future people can see what you have done.

[labskaus]

oh ... please also add my Thread in Audio Builds

http://www.ft86club.com/forums/showthread.php?t=47487

[rupert]

Originally Posted by labskaus

oh ... please also add my Thread in Audio Builds

http://www.ft86club.com/forums/showthread.php?t=47487

Done!

[CamryDS]

I'm getting my system upgraded =) stay tuned for another build thread.

[jeffsquared]

Suggest adding these android HU threads?

Another Android Head Unit

Another Android radio (KGL/Klyde/RoadMaster/GS/JY/MD) - Scion FR-S Forum | Subaru BRZ Forum | Toyota 86 GT 86 Forum | AS1 Forum - FT86CLUB

[RJ_]

Has anyone installed one of the small Focal FD amps yet?

[kenrickv]

I've read somewhere in these posts about the unused 6 pin harness behind the stereo. It had constant 12 volt, an accessory 12v, a ground and a couple CAN signals. I can't seem to find the pin out. Anyone remember what thread this was in?

Edit: got the info needed. Pin 3 is 12V switched and pin 2 is ground. Powers an Alpine KPT amp pretty good.

[reynierpm]

Originally Posted by rupert

General Information

Speaker Sizes

• Tweeter: 1"
• Midrange: 3.5" (Depth: 2")
• Woofer - 6.5" (Depth: 2" without spacers)
• Rear - 3.5" (Depth: omgwtfbbq a.k.a. enough)

Is this information accurate for a Toyota 86 2017?