Electric Exhaust Cutout = Loud as %$#@

[2thdoc]

where did you put the cutout?

[Wyattkb]

Originally Posted by M-17

Don't want to throw anyone under the bus, but let me make it clear. It wasn't me who said that.

Anyway here's a couple of pics from underneath the car.

Reviving this thread from the dead because I would like to see where you had this installed.

Anyway you can re-upload the pics?

[andrew5826]

Originally Posted by M-17

Don't want to throw anyone under the bus, but let me make it clear. It wasn't me who said that.

Anyway here's a couple of pics from underneath the car.

i would like to see as well!

[M-17]

Originally Posted by Wyattkb

Reviving this thread from the dead because I would like to see where you had this installed.

Anyway you can re-upload the pics?

Originally Posted by andrew5826

i would like to see as well!

If I find the pictures, I will re-post them. I'm not sure what happened to the previous pics I posted before.

[Koa]

Originally Posted by mad_sb

Yeah, I have been thinking about having something made using a universal Varex... mainly for the early am and late night cold start... that first 30 seconds while the timing is at -10* and the throttle plate is open is just too loud for my taste, and is about to be even louder with a catless header. Once the idle kicks down it's fine.

Why not just tone down the cold start to -4 across the board and change the maf correction after start table to have rpms at a cool, easy 1400?

[keithr]

All that's old becomes new again...

In the 60's they called these "dumpers."

[bee_are_zee]

not sure how this setup is but I made a modified front pipe using a weld in y pipe with a cutout and turn down. All 2.5 in with he cutout just under the driver seat.**I went with cheap eBay components but I only have 200 in the setup.

[andrew5826]

i got mine installed. chopped out the resonator in the mid pipe and welded it in

check it: https://instagram.com/p/0c1UyHRDyD/?taken-by=86guo

[Wyattkb]

Originally Posted by andrew5826

i got mine installed. chopped out the resonator in the mid pipe and welded it in

check it: https://instagram.com/p/0c1UyHRDyD/?taken-by=86guo

That looks very clean. Anyway you can post a larger picture of it? I'd like to show my fabricators an example.

[andrew5826]

Originally Posted by Wyattkb

That looks very clean. Anyway you can post a larger picture of it? I'd like to show my fabricators an example.

ask and you shall receive

[KungFuWaffle]

Thread revival, how did you wire it into the car?

[bee_are_zee]

Through the shifter boot to under the center console.

[KungFuWaffle]

Originally Posted by bee_are_zee

Through the shifter boot to under the center console.

Do you have a picture?

[bee_are_zee]

Originally Posted by KungFuWaffle

Do you have a picture?

Sorry. Didn't see this until today. I should be under the car today I will try and grab some pictures. Basically poked a hole in the corner of the rubber shift boot under the leather one and ran the wire along the side of the transmission tunnel using wire sticky pads to hold it in place.