|
Engine, Exhaust, Transmission Discuss the FR-S | 86 | BRZ engine, exhaust and drivetrain. |
|
Thread Tools | Search this Thread |
10-22-2014, 10:59 PM | #1 |
Member
Join Date: Apr 2014
Drives: 2013 Asphalt FRS 6AT
Location: Baltimore MD
Posts: 39
Thanks: 8
Thanked 2 Times in 2 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
What gaskets do I need????
So I'm replacing my factory header with a borla, and my factory catback with a perrin. What gaskets do I need to replace? I've found I'll need 2 exhaust manifold gaskets and maybe 3 2.5" exhaust gaskets?
Any advice is appreciated. Thanks! |
10-22-2014, 11:07 PM | #2 |
Off Topic
Join Date: Feb 2014
Drives: 2014 Subaru BRZ Limited
Location: Vegas, baby!
Posts: 4,610
Thanks: 2,369
Thanked 4,243 Times in 2,170 Posts
Mentioned: 43 Post(s)
Tagged: 3 Thread(s)
|
Get GrimmSpeed exhaust manifold gaskets. They're just better.
|
10-22-2014, 11:25 PM | #3 |
Senior Member
Join Date: Aug 2012
Drives: '13 DGM BRZ Limited
Location: NJ
Posts: 1,201
Thanks: 59
Thanked 547 Times in 339 Posts
Mentioned: 8 Post(s)
Tagged: 0 Thread(s)
|
Perrin catback should come with gaskets unless you're buying used. It uses v-band clamps so the only gasket you'll need is the one from the stock cat to the mid-pipe connection which comes with the exhaust from Perrin.
For the header install, I would use GrimmSpeed manifold gaskets as recommended above and you'll need 1 additional 2.5" gasket for the header to OP connection. |
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Door window gaskets? | dtrop | Issues | Warranty | Recalls / TSB | 4 | 07-03-2014 05:00 PM |
Perrin cbe gaskets. | merino_frs | Engine, Exhaust, Transmission | 5 | 01-06-2014 03:32 PM |
Exhaust Gaskets | Trashed675 | Engine, Exhaust, Transmission | 4 | 11-19-2013 07:43 PM |
Gaskets | Hawk77FT | Engine, Exhaust, Transmission | 2 | 09-27-2013 07:45 PM |
Header gaskets | Motordyne | Engine, Exhaust, Transmission | 1 | 06-23-2012 04:31 PM |