Trim around back window removal?

[FastLap]

Has anybody done a write up on how to remove the trim pieces around the back window? I’m wanting to route a dashcam wire from the floor up to the center of the back window and am needing to figure out how to remove some of the trim in order to accomplish this.

[Wally86]

I think this should help?

[FastLap]

Originally Posted by Wally86

I think this should help?

Thanks... that almost helps but I really need to know how the side pieces come off, the plastic pieces between the seat and the headliner... between the back glass and the small side piece of glass.

[Wally86]

Originally Posted by FastLap

Thanks... that almost helps but I really need to know how the side pieces come off, the plastic pieces between the seat and the headliner... between the back glass and the small side piece of glass.

https://www.ft86club.com/forums/showthread.php?t=64362

[FastLap]

Originally Posted by Wally86

https://www.ft86club.com/forums/showthread.php?t=64362

Getting closer haha. I really need to know how to remove the piece between the ceiling and the area right behind the back seat. I have a wire run to the bottom of the trunk behind the seats and need to feed it up to the top center of the back window for the rear camera.

[soundman98]

step 1 remove rear seat, bottom and top.

step 2 pull!

[danson]

Lol I pried it back alittle and stuffed like 6 ft of cable for my rear cam in there. Plenty of room!

[FastLap]

Originally Posted by danson

Lol I pried it back alittle and stuffed like 6 ft of cable for my rear cam in there. Plenty of room!

The tricky part for me is routing the wire above the airbag so the wire doesn’t interfere… that’s why I don’t want to stuff it in from below.

[soundman98]

i had pulled that panel to remove the rear speakers, and run amp cabling on the passenger side. a ton of useless work. i only did the passenger side, i left the drivers side.

i believe the side airbag stops at the plastic trim just behind the front seats, as the rear speaker/window trim is one complete molding. but it's been a long time, and i've repressed all the details

[FastLap]

Originally Posted by soundman98

i had pulled that panel to remove the rear speakers, and run amp cabling on the passenger side. a ton of useless work. i only did the passenger side, i left the drivers side.

i believe the side airbag stops at the plastic trim just behind the front seats, as the rear speaker/window trim is one complete molding. but it's been a long time, and i've repressed all the details

Yeah, I was able to pull one small section of the trim down some and the airbag definitely extends all the way to the back window edge… covers the entire area to the side of the back seats with the side curtain all the way up to the front windshield.