Rear Deck "popping/clicking/tapping/ticking" noise. - Page 31 - Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community

tonystewart · 07-21-2013, 02:09 PM

I used Raammat, the area doesn't rattle anymore

I also did the opposite side

beachbum · 07-24-2013, 02:15 PM

Quote:

Originally Posted by Mikepage

I fixed mine finally, with this : Under glass cardboard

Cost : 0$

Result : No noise anymore

Thanks. I did this and it worked. No more rattle and clicking.
The other people are just wasting their time and cash.

Marrk · 07-24-2013, 02:22 PM

^^I admire the elegance of this solution. It's clean, simple, dirt cheap, and completely reversible.

van_fc3s · 07-26-2013, 12:35 AM

thank you for the solution. It was bothering me for weeks and a common wd40 does wonders. so far so good and fingers crossed.

avholic · 07-27-2013, 10:44 PM

The TSB for rear-deck popping issue didn't work on my car, so the dealer/service dept did this to fix the issue.

Now I need to buy some spray paint to keep the rust off. I should have tried the suggestions on this thread before getting the warranty work done. Too late now.

tonystewart · 07-28-2013, 10:11 AM

Yes

mmarkFRS · 07-31-2013, 09:46 AM

There is an area in the roof, where there are two spot welds right above thedriver side. Locating this was very difficult. It was only after I exhaustedevery possibility that I was able to find this. I literally had the back seatdown to the metal.

This spot was very deceptive; I thought it was in the trunk, or the air bagfasteners. Needless to say it wasneither of these issues. I also triedcenter punching the spot welds in the trunk, and taping down the fasteners inthe trunk below the spare tire.

If you remove the top ceiling (there are three plastic fasteners that holdthe ceiling in place). And you removethe side panel on the driver’s side you will see a dip in the metal directlyabove the driver side (right behind the sensor). If you put a little pressure on this spot therattle stops.

I took a piece of a rubber door stop and wedged it in, and this correctedthe rattle. I will be posting picturessoon.

I hope this helps.

ayilar · 07-31-2013, 09:36 PM

Quote:

Originally Posted by Marrk

^^I admire the elegance of this solution. It's clean, simple, dirt cheap, and completely reversible.

Thanks a lot for this. First experienced a ticking/clicking sound 3 months ago -- fixed by opening and closing the rear seatback. Experienced a similar noise again at the end of a 3k mile trip through twisties. This time opening/closing the seatback did not help, indeed if anything the sound got worse. After reading this thread, I tried a glass coaster-like solution. It worked in that 90% of the sound is gone. Reversibility is key to me.

Will experiment with variations in the next 2-3 weeks and hope to get 100% solved.

Only issue I've had with my car.

djdnz · 08-01-2013, 09:40 AM

Quote:

Originally Posted by avholic

The TSB for rear-deck popping issue didn't work on my car, so the dealer/service dept did this to fix the issue.

Now I need to buy some spray paint to keep the rust off. I should have tried the suggestions on this thread before getting the warranty work done. Too late now.

WTF!!!!

Send this to Subaru and get some sort of compensation. No way they should have done that to a brand new car.

I brought mine in yesterday and they fixed the rattle for me using the TSB, but reading this thread makes me worry it might come back. We shall see. For the moment I am a happy camper, this noise was driving me bananas.

Marrk · 08-01-2013, 01:45 PM

Quote:

Originally Posted by avholic

The TSB for rear-deck popping issue didn't work on my car, so the dealer/service dept did this to fix the issue.

Now I need to buy some spray paint to keep the rust off. I should have tried the suggestions on this thread before getting the warranty work done. Too late now.

That's appalling. I don't think of this as a "grey area" f*ck *p. This is a solidly in the Red Zone f*ck *p.

Sideways? · 08-02-2013, 01:52 AM

Quote:

Originally Posted by avholic

Now I need to buy some spray paint to keep the rust off. I should have tried the suggestions on this thread before getting the warranty work done. Too late now.

Why do you need to buy some spray paint?! Surely the cack-handed dealer that did such an appalling job in the first place should be doing the touch-up... At least...!!!

im2fr-s · 08-06-2013, 08:33 PM

Took the ride into the dealer today for the third time to fix this issue. It looks like they finally found it... so far no clunk. The pics show where the noise was coming from. It's the drivers side of the trunk. You can also see where they used a hammer drill to tap the welds. Hope this helps.

Sent from my SPH-L720 using Tapatalk 2

PNW FRS · 08-07-2013, 10:15 PM

And as noted in OP.. only took about 30 seconds...

http://www.ft86club.com/forums/showthread.php?t=42065

PNW FRS · 08-08-2013, 08:15 PM

Unbelievable... taking a hammer and whatever else to pound on the area and break the paint. This should be brought to the attention of the Regional Service Manager... completely unacceptable "service".

07-21-2013, 02:09 PM	#421
tonystewart Senior Member Join Date: May 2012 Drives: 2013 Scion FR-S Raven Location: Lake Worth Florida Posts: 1,181 Thanks: 76 Thanked 366 Times in 252 Posts Mentioned: 13 Post(s) Tagged: 1 Thread(s)	I used Raammat, the area doesn't rattle anymore I also did the opposite side __________________ May'12 AT Raven, OFT V2, Perrin IntakeTube, Pulley & Overpipe,HKS Snorkel,FA20 EL Header,Nameless Frontpipe w/ Helmholtz, Crawford AOS, Cusco O2W Cooler, Grimmspeed Strut/MC Brace, Winjets w/D2S 3.0 HID by Illuminating Lighworkx, Fogs w/EU Stalk, LED's, JDM UnderPanels, Diffuser, Rigid Collars, Whiteline, HVT Camber Plates, Koni's, Swift Springs, GTSpec LCA, SPC Toearms, DBA 4K T-Slot Rotors, Ferodo DS2500, Vorshlag BrakeLines, MichelinPSS, 5Axis Wing, Raammat, Ensolite, JPM Coachworks, OEM+Ref400, 20mmspacers, TOMS

07-28-2013, 10:11 AM	#426
tonystewart Senior Member Join Date: May 2012 Drives: 2013 Scion FR-S Raven Location: Lake Worth Florida Posts: 1,181 Thanks: 76 Thanked 366 Times in 252 Posts Mentioned: 13 Post(s) Tagged: 1 Thread(s)	Yes __________________ May'12 AT Raven, OFT V2, Perrin IntakeTube, Pulley & Overpipe,HKS Snorkel,FA20 EL Header,Nameless Frontpipe w/ Helmholtz, Crawford AOS, Cusco O2W Cooler, Grimmspeed Strut/MC Brace, Winjets w/D2S 3.0 HID by Illuminating Lighworkx, Fogs w/EU Stalk, LED's, JDM UnderPanels, Diffuser, Rigid Collars, Whiteline, HVT Camber Plates, Koni's, Swift Springs, GTSpec LCA, SPC Toearms, DBA 4K T-Slot Rotors, Ferodo DS2500, Vorshlag BrakeLines, MichelinPSS, 5Axis Wing, Raammat, Ensolite, JPM Coachworks, OEM+Ref400, 20mmspacers, TOMS

07-31-2013, 09:46 AM	#427
mmarkFRS Junior Member Join Date: Jul 2013 Drives: 2013 Scion FR-S Raven Location: Indianapolis Posts: 1 Thanks: 0 Thanked 1 Time in 1 Post Mentioned: 0 Post(s) Tagged: 0 Thread(s)	Found rattle in ceiling area and I was able to solve There is an area in the roof, where there are two spot welds right above thedriver side. Locating this was very difficult. It was only after I exhaustedevery possibility that I was able to find this. I literally had the back seatdown to the metal. This spot was very deceptive; I thought it was in the trunk, or the air bagfasteners. Needless to say it wasneither of these issues. I also triedcenter punching the spot welds in the trunk, and taping down the fasteners inthe trunk below the spare tire. If you remove the top ceiling (there are three plastic fasteners that holdthe ceiling in place). And you removethe side panel on the driver’s side you will see a dip in the metal directlyabove the driver side (right behind the sensor). If you put a little pressure on this spot therattle stops. I took a piece of a rubber door stop and wedged it in, and this correctedthe rattle. I will be posting picturessoon. I hope this helps.

08-06-2013, 08:33 PM	#432
im2fr-s Senior Member Join Date: Jul 2012 Drives: 2013 FR-S Location: FL East Coast Posts: 117 Thanks: 3 Thanked 21 Times in 6 Posts Mentioned: 1 Post(s) Tagged: 0 Thread(s)	Took the ride into the dealer today for the third time to fix this issue. It looks like they finally found it... so far no clunk. The pics show where the noise was coming from. It's the drivers side of the trunk. You can also see where they used a hammer drill to tap the welds. Hope this helps. Sent from my SPH-L720 using Tapatalk 2 Attached Images

08-07-2013, 10:15 PM	#433
PNW FRS Senior Member Join Date: Sep 2012 Drives: 2013 Scion FR-S Location: Olympia, WA Posts: 581 Thanks: 230 Thanked 342 Times in 189 Posts Mentioned: 7 Post(s) Tagged: 1 Thread(s)	Try this solution.. it seems to have worked for me... And as noted in OP.. only took about 30 seconds... http://www.ft86club.com/forums/showthread.php?t=42065 __________________ 2013 Asphalt / MT Olympia, Washington

07-24-2013, 02:22 PM	#423
Marrk Senior Member Join Date: Jul 2011 Drives: Honda Fit Location: Los Angeles Posts: 1,004 Thanks: 722 Thanked 125 Times in 90 Posts Mentioned: 2 Post(s) Tagged: 0 Thread(s)	^^I admire the elegance of this solution. It's clean, simple, dirt cheap, and completely reversible.

07-26-2013, 12:35 AM	#424
van_fc3s Member Join Date: May 2013 Drives: GT86 Location: Vancouver Posts: 43 Thanks: 278 Thanked 4 Times in 3 Posts Mentioned: 0 Post(s) Tagged: 0 Thread(s)	thank you for the solution. It was bothering me for weeks and a common wd40 does wonders. so far so good and fingers crossed.

07-27-2013, 10:44 PM	#425
avholic Senior Member Join Date: Apr 2012 Drives: BRZ WRBL6MT Location: Earth Posts: 106 Thanks: 3 Thanked 91 Times in 18 Posts Mentioned: 2 Post(s) Tagged: 0 Thread(s)	The TSB for rear-deck popping issue didn't work on my car, so the dealer/service dept did this to fix the issue. Now I need to buy some spray paint to keep the rust off. I should have tried the suggestions on this thread before getting the warranty work done. Too late now.

08-08-2013, 08:15 PM	#434
PNW FRS Senior Member Join Date: Sep 2012 Drives: 2013 Scion FR-S Location: Olympia, WA Posts: 581 Thanks: 230 Thanked 342 Times in 189 Posts Mentioned: 7 Post(s) Tagged: 1 Thread(s)	Unbelievable... taking a hammer and whatever else to pound on the area and break the paint. This should be brought to the attention of the Regional Service Manager... completely unacceptable "service". __________________ 2013 Asphalt / MT Olympia, Washington

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Odometer Functions - "S" & "G" What are they?	kablammo	BRZ First-Gen (2012+) -- General Topics	59	12-01-2013 12:28 AM
NEW Volk Racing TE37SL "Black Edition" Different finish, same low price!	Speed Element	Wheels and Tires	19	07-19-2012 02:27 PM
Subaru BRZ Prototype First Drive Review: "Off the Chart" (Motor Trend)	Hachiroku	BRZ First-Gen (2012+) -- General Topics	67	11-09-2011 05:58 PM
May 2010 Car&Driver issue FT-86 article - "25 Cars Worth Waiting For"	JDMinc	Scion FR-S / Toyota 86 GT86 General Forum	76	04-17-2010 03:58 AM

User Name		Remember Me?
Password