WHAT DID YOU DO TO YOUR FRS TODAY? - Page 1159 - Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community

dhuang · 04-10-2017, 06:14 PM

Quote:

Originally Posted by humfrz

Ahhhhhh yes, ........ good plan ...... reduced visibility tail lights ....... keep them tailgaters guessing .......

(pay no never mind to humfrz this week ....... it's spring break and all three of the granddaughters are over at his place all day, every day for a week).

humfrz

Trust me, they are still much much brighter than stock -- Especially the turn signals! It's just the inner housing that's painted dark to give the illusion you're experiencing. Unlike the design of original Valenti taillights, the Revos are much more refined.

humfrz · 04-10-2017, 06:38 PM

Quote:

Originally Posted by dhuang

Trust me, they are still much much brighter than stock -- Especially the turn signals! It's just the inner housing that's painted dark to give the illusion you're experiencing. Unlike the design of original Valenti taillights, the Revos are much more refined.

Ahhhhh....... see......thanks for the information ......

humfrz

MyNameIsKeh · 04-10-2017, 07:38 PM

Quote:

Originally Posted by James The Giant

Had my cracked 10 series bumper replaced with a 2017 BRZ bumper

Nice! got any more pics?

notout86 · 04-10-2017, 10:08 PM

Quote:

Originally Posted by humfrz

I suggest you put a half of a can of this under your car each night and leave the garage door open a bit (if garaged) ....... you won't have any more rodent damage ......

humfrz

They could be getting in via a hole by the rubber cover in the front lowest part of the rear wheels arch.
If you get inside the rear of the car, remove the trim with the armrest & peer towards the rear behind the arch you can see daylight.

PDM 2 · 04-11-2017, 11:08 AM

Put on my tails yesterday!

Was in the process of putting the smoked GCS 4th brake light.. but the wiring has got me all F*cked up! -___- now there's just a empty space where my 4th brake light is until i get the wiring right

StraightOuttaCanadaEh · 04-11-2017, 11:10 AM

Quote:

Originally Posted by PDM 2

Put on my tails yesterday!

Was in the process of putting the smoked GCS 4th brake light.. but the wiring has got me all F*cked up! -___- now there's just a empty space where my 4th brake light is until i get the wiring right

Is there a shop that can do it around scarberia?

Firecruiser · 04-11-2017, 12:09 PM

Quote:

Originally Posted by PDM 2

Put on my tails yesterday!

Was in the process of putting the smoked GCS 4th brake light.. but the wiring has got me all F*cked up! -___- now there's just a empty space where my 4th brake light is until i get the wiring right

I dealt with the wiring on the GCS 4th brake light. I have some info in my post here.
http://www.ft86club.com/forums/showthread.php?t=114970

MJones_RB · 04-11-2017, 12:36 PM

Quote:

Originally Posted by James The Giant

Had my cracked 10 series bumper replaced with a 2017 BRZ bumper

Looks great from that angle, how's the fitament?

James The Giant · 04-11-2017, 12:55 PM

Fitment is spot on, had the work done by Pure Automotive. Will post more pics later today

VMRamos · 04-11-2017, 02:38 PM

Quote:

Originally Posted by James The Giant

Had my cracked 10 series bumper replaced with a 2017 BRZ bumper

Looks great!

I just got my front bumper cracked too by an animal jumping in front my car. I want to get the 2017 bumper as well.

If you went through insurance, was it too much of a hassle to ask for the 2017 bumper instead? Trying to figure out how to go about it.

Sent from my iPhone using Tapatalk

OrangeGuitar · 04-11-2017, 03:01 PM

Quote:

Originally Posted by VMRamos

If you went through insurance, was it too much of a hassle to ask for the 2017 bumper instead? Trying to figure out how to go about it.

Normally you can swap in other parts and pay the difference in price if there is any. Accidents can be an upgrade opportunity with the repair shop of your choice.

Sent from my iPhone using Tapatalk

Captain_Awesome_Pants · 04-11-2017, 03:41 PM

The stuff nightmares are made of... Wanted to darken the silver interior bits and add some texture, so I vinyl wrapped them. Took the opportunity to add some JDM door items and JPM speaker pads too. Probably should have cleaned the doors before pics.

Also wrapped my dash in Alcantara...

EnoOnraefi · 04-11-2017, 06:17 PM

Quote:

Originally Posted by Captain_Awesome_Pants

The stuff nightmares are made of... Wanted to darken the silver interior bits and add some texture, so I vinyl wrapped them. Took the opportunity to add some JDM door items and JPM speaker pads too. Probably should have cleaned the doors before pics.

Also wrapped my dash in Alcantara...

I did some vinyl work as well... Then I decided to adjust the clutch grab point and install the intech high point brake light that has been sitting in the car in its box for a few days... And in the middle of removing the "flying saucer" I got to go searching for a clip that dropped down into the frame...

I'm going to have to re-wrap the shifter trim though... I totally botched the inset for the traction control buttons. Damn vinyl started ripping...

ichitaka05 · 04-11-2017, 06:40 PM

Quote:

Originally Posted by Captain_Awesome_Pants

...

Quote:

Originally Posted by EnoOnraefi

...

Damn, you guys are good... I did my dash panel and it was a bitch!

Any tip on doing the inside or the hole area?

04-11-2017, 11:08 AM	#16217
PDM 2 Pokemon Master Join Date: Sep 2016 Drives: 2014 Scion FR-S Location: Scarborough, Ontario Posts: 204 Thanks: 57 Thanked 76 Times in 45 Posts Mentioned: 0 Post(s) Tagged: 0 Thread(s)	Put on my tails yesterday! Was in the process of putting the smoked GCS 4th brake light.. but the wiring has got me all Fcked up! -___- now there's just a empty space where my 4th brake light is until i get the wiring right __________________ '10 MazdaSpeed 3 Velocity Red Mica - SOLD* PDM 2 '14 Scion FR-S MT FireStorm Red STAGE 2 + - FIVE AXIS BODY KIT - HKS DROPIN - INVIDIA N1 - GRUPPE-S UEL- ENKEI LUSSO 18X7.5 +42 - ST COILOVERS

04-11-2017, 03:41 PM	#16224
Captain_Awesome_Pants Senior Member Join Date: Feb 2013 Drives: FR-S: Firestorm Location: NC Posts: 171 Thanks: 97 Thanked 116 Times in 56 Posts Mentioned: 1 Post(s) Tagged: 0 Thread(s)	The stuff nightmares are made of... Wanted to darken the silver interior bits and add some texture, so I vinyl wrapped them. Took the opportunity to add some JDM door items and JPM speaker pads too. Probably should have cleaned the doors before pics. Also wrapped my dash in Alcantara... Last edited by Captain_Awesome_Pants; 04-11-2017 at 05:04 PM.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Saw My First FR-S Today	Marrk	Scion FR-S / Toyota 86 GT86 General Forum	26	05-15-2013 12:40 PM
Got My Car Today!!!!! First 86!! #81	Juanito08	Scion FR-S / Toyota 86 GT86 General Forum	7	05-22-2012 04:54 PM
If my FRS was here already, today I would...	bestwheelbase	Scion FR-S / Toyota 86 GT86 General Forum	101	05-12-2012 06:20 PM
Sat in a FRS today!!	Ladnerd	Scion FR-S / Toyota 86 GT86 General Forum	12	04-30-2012 01:48 PM
Got my VIN today...	Enemies	BRZ First-Gen (2012+) -- General Topics	63	04-12-2012 10:19 PM

04-11-2017, 12:55 PM	#16221
James The Giant Member Join Date: Apr 2015 Drives: 2013 10 Series Scion Frs Location: Maryland Posts: 45 Thanks: 12 Thanked 21 Times in 12 Posts Mentioned: 0 Post(s) Tagged: 0 Thread(s)	Fitment is spot on, had the work done by Pure Automotive. Will post more pics later today

User Name		Remember Me?
Password