|
Electronics | Audio | NAV | Infotainment Anything related to in-car electronics, navigation, and infotainment. |
|
Thread Tools | Search this Thread |
07-05-2013, 10:05 PM | #1 |
Member
Join Date: May 2013
Drives: BRZ
Location: Melbourne
Posts: 71
Thanks: 12
Thanked 64 Times in 25 Posts
Mentioned: 2 Post(s)
Tagged: 0 Thread(s)
|
DIY phone mount
Hey guys,
have been struggling with phone mounting options in my BRZ for about 2mths now, and have finally found a DIY solution. I am using an iphone 4s for the moment, but clic-on make docks for heaps of different smart phones with the same mounting points. Parts used: - Iphone 4s Thru connector holder - Male to female 30pin iphone cable extender - 2mm MDF - Pebble black trim - Cable ties Started off with cutting out a ring to sit flush against the drivers side air vent (84mm) Removed the air vent, cut the top and bottom off the backing piece then soaked in MDF glue to add some strength. Finally trimmed in pebble black vinyl Pre-drilled the mounting screws for the dock test fitting together Fed the iphone cable extender through the back of the air vent Tucked the cable in behind the dash, back to the HU input All back together, air vent is now permanently open as I cable tied the mount to the backing plate, and back or air vent to hold all the bits in Pat on the back for a job well done |
The Following User Says Thank You to GaDgeT For This Useful Post: | unsurety (02-08-2017) |
07-05-2013, 10:11 PM | #2 |
PROUD OF BOXER
Join Date: Feb 2013
Drives: Raven FR-S
Location: Huntsville, AL
Posts: 668
Thanks: 221
Thanked 356 Times in 169 Posts
Mentioned: 5 Post(s)
Tagged: 0 Thread(s)
|
Nice write up! I might go this route myself. I hardly ever use that vent and have been wanting something to mount my s3 during autocrossing for the Torque app. What was the total cost of the build??
Thanks!
__________________
|
07-05-2013, 10:18 PM | #3 |
Member
Join Date: May 2013
Drives: BRZ
Location: Melbourne
Posts: 71
Thanks: 12
Thanked 64 Times in 25 Posts
Mentioned: 2 Post(s)
Tagged: 0 Thread(s)
|
$125 for the dock, $5 for the cable, the rest I had lying around but whole project cost less than $150
|
|
|
Thread Tools | Search this Thread |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Custom phone mount | so26 | DIY (Do-It-Yourself) Guides | 20 | 11-07-2016 04:15 PM |
Ideas for a hidden magnetic phone-mount. | MmmDieselFumes | Cosmetic Modification (Interior/Exterior/Lighting) | 40 | 05-09-2016 01:14 PM |
Phone holder | Tim_Asphalt_FRS | Cosmetic Modification (Interior/Exterior/Lighting) | 79 | 04-02-2016 03:28 PM |
DIY: Making a GoPro camera mount with a GrimmSpeed front plate mount | PMok | DIY (Do-It-Yourself) Guides | 2 | 06-11-2013 10:58 AM |
Phone app. | DanoFA20 | Site Announcements / Questions / Issues | 6 | 10-22-2012 11:55 PM |