My Shift Knob. Post yours too

[Nitesh31]

Close up on perforation

[chanomatik]

Originally Posted by chuyjr85

Badass! Where can i get 1 of these?

Check Group Buys. @Anarchy Motive is having another one starting tomorrow!

[B L U E S L A T E]

Does anyone have a tapped/drilled Tommy Kaira Heavy Baby?

[B L U E S L A T E]

Originally Posted by chanomatik

$100 for a good shift knob ain't nothin'!

Here's my new Cardinal Sin Anarchy Motive shift knob.

I like this red better than the other one.

[Kostamojen]

Just arrived. Someone try the part number!

[canon_spec]

Originally Posted by Ray_32

Custom Hybrid Piston Shift Knob from WC Lathe Werks.

Just got it recently and haven't got to changing it yet. The top cap of the stock knob is beginning to come loose so this could just be perfect timing .

Attachment 50951

Have you had a chance to try it out? Actually looking to get the same.

Not sure thou if it will fit my style of shifting as I tend to grab the knob at the top.. (no pun intended).lol

[hotpanda1]

Blox shift knob

[ck-GT86]

Here's my Moddiction Anvil 2 Textured Black shift knob. The knob is countersunk, so it'll stop the reverse-lock from functioning properly if you thread it all the way down. I was going to follow @PMok 's suggestion of using thread locker, but I found teflon tape (plumber's tape) to work much better.



I'm not a huge fan of sphere-type shift knobs, I like the Anvil 2 because it has a big resemblance to an S2000 shift knob (which feels GREAT).

As you can see the picture above, the threaded golden ring is actually inside the Anvil 2; the knob itself is threaded, and the threaded golden ring threads to that, which then threads to your shifter. If you apply enough teflon tape, you can get the golden ring to come off of the shift knob and sit at the top of the shifter like mine. Apply even more teflon tape to give you a snug fit as you thread the shifter on -- thread to your most comfortable height and test out the reverse-lock. I haven't had a chance to take the car around the block, but it seems to work at that height getting into reverse

Thanks @Moddiction !! I love this shift knob!


.ck

[Kostamojen]

Sorry for the shitty pic, but here is the JDM base model GT86 knob installed:

(I'll get a better pic later with a real camera)

[Hiros86]

Love this shift knob! WC Lathe Werks Titanium/bronze

[RainEG]

Anyone know the thread pitch size; 12x1.25, 10x1.25, ....

[Moddiction]

Manual trans is 12x1.25.

[Kostamojen]

Slightly better shift knob pic XD

[Nitesh31]

@Phaedrus29