|
||||||
| Software Tuning Discuss all software tuning topics. |
 |
|
|
Thread Tools | Search this Thread |
11-18-2018, 09:59 PM
|
#1 |
|
Senior Member
Join Date: Jan 2016
Drives: 2013 Panda ft86/FRS
Location: Oklahoma, USA
Posts: 147
Thanks: 22
Thanked 21 Times in 17 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
OFT Omni 3 bar map question
Just want to verify my conversion, I've researched but I'd like just a confirmation as the factory setting on the map offset (psia) is -2.901 and the multiplier is (psia/v) 4.834 and well sensor settings is
Omni 3 Bar MAP Sensor (Metric in Bar) 0.617 - MULTIPLIER 0.03 - OFFSET scaling limits 0 - 4.75v so if I convert it comes out to (psia) is .435 and the multiplier is (psia/v) 8.934 is this right? Id figure I should see a negative in there, but... well all help is appriciated |
|
|
|
| Thread Tools | Search this Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Sold Omni 3-bar MAP | zkv476 | Engine, Exhaust, Bolt-Ons | 0 | 09-28-2016 11:35 PM |
| omni 4 bar | Shit Luck | Engine, Exhaust, Bolt-Ons | 3 | 05-22-2014 08:32 PM |
| WTB: 3 or 4 bar Omni Map sensor | sissupr | Engine, Exhaust, Bolt-Ons | 0 | 05-16-2014 01:24 PM |
| Omni 4 Bar Map Sensor New | Cross | Engine, Exhaust, Bolt-Ons | 3 | 04-06-2014 02:31 PM |
| FS: NY - Omni 3 Bar Map Sensor | xxscaxx | Engine, Exhaust, Bolt-Ons | 7 | 03-11-2014 11:41 AM |
