|
Electronics | Audio | NAV | Infotainment Anything related to in-car electronics, navigation, and infotainment. |
|
Thread Tools | Search this Thread |
07-11-2019, 11:03 PM | #1 |
Junior Member
Join Date: May 2019
Drives: 2013 frs
Location: Yucca valley
Posts: 9
Thanks: 0
Thanked 0 Times in 0 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
Rear view camera
So I tapped into the reverse trigger wire from the fuse box and I don’t find where to tap the cameras red wire
Sent from my iPhone using Tapatalk |
07-11-2019, 11:03 PM | #2 |
Junior Member
Join Date: May 2019
Drives: 2013 frs
Location: Yucca valley
Posts: 9
Thanks: 0
Thanked 0 Times in 0 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
I’ve already looked at others but it wasn’t helpful to me
Sent from my iPhone using Tapatalk |
07-11-2019, 11:05 PM | #3 |
Junior Member
Join Date: May 2019
Drives: 2013 frs
Location: Yucca valley
Posts: 9
Thanks: 0
Thanked 0 Times in 0 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
This red wire is what’s confusing me I hooked it up to the purple wire but nothing, reveres comes into play just shows a black page Sent from my iPhone using Tapatalk |
07-11-2019, 11:10 PM | #4 |
Member
Join Date: May 2019
Drives: FRS 10 Series
Location: Florida
Posts: 32
Thanks: 3
Thanked 18 Times in 9 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
Sounds like we can rule some things out then. A black screen when shifting into reverse means that the head unit is properly receiving the signal to switch to video input mode upon receiving power, so that part of the wiring is right, but there’s no video to display. This means that either the camera isn’t receiving power, or just not transmitting a video signal properly into the head unit.
|
07-12-2019, 03:49 AM | #5 |
Member
Join Date: Jul 2018
Drives: '13 Scion FR-S
Location: Jacksonville, FL
Posts: 19
Thanks: 2
Thanked 17 Times in 9 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
If I recall correctly, the red wire just needs to be attached to a switchable power source. Reverse light for example. Been so long since I've done mine, I can't remember where I finally hooked it up, but I know that's what I did to test it and verify the camera works.
|
07-14-2019, 10:09 PM | #6 |
Senior Member
Join Date: Jan 2016
Drives: 2016 4Runner / 2016 FR-S
Location: Brampton, Ontario
Posts: 142
Thanks: 18
Thanked 58 Times in 36 Posts
Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
|
6V power
I hope its not too late but if you're using the factory camera DO NOT connect the camera directly to a 12V source like the reverse lights! You'll most likely kill it. You're supposed to use something like a buck converter to step it down to 6V. I've installed an aftermarket head unit in my 2016 FR-S and I had to use a step down converter. You most likely will need to use one also.
__________________
I pay more per month for insurance than I pay for the FRS.
|
|
|
Thread Tools | Search this Thread |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Rear view camera | Sasquachulator | Scion FR-S / Toyota 86 GT86 General Forum | 10 | 08-20-2018 08:52 AM |
I need help about rear view camera | bartuc | Electronics | Audio | NAV | Infotainment | 3 | 11-26-2017 09:03 PM |
Rear View Camera *Fail* | FNCrazy | Electronics | Audio | NAV | Infotainment | 6 | 07-24-2016 08:48 PM |
stock brz jdm rear view camera | SuperDave | Electronics | Audio | NAV | Infotainment | 0 | 04-03-2014 09:53 AM |
be spoke w rear view camera | xpicer | Electronics | Audio | NAV | Infotainment | 17 | 10-14-2012 09:26 AM |