Post a pic of your installed Autopower roll bar

[zdr93523]

Originally Posted by forwallblakmail

Even with the diagonal bar being at an angle as it intersects the harness bar? (I have the 4pt in my car now). I've been told by NASA guys it wont pass if I turn it into the full cage.

Correct, the 4 point is not legal. The full bolt in or weld in cage is legal. They have a slightly different design. The cage diagonal is not dead straight but falls within the acceptable design per the NASA CCR.

[avishenoy1]

Originally Posted by DavidBob

I have their four point cage if you'd like I can snap some pictures and post them up here

I'd appreciate if you could post pics.

[15limited]

Originally Posted by Apex-Apex

Hey how'd you figure out where to cut your rear plastic trim so it fits around the rear post? Did you have to trim anything else to make it fit? Looks great man

Sent from my SM-G950U using Tapatalk

[Apex-Apex]

Originally Posted by 15limited

Hey how'd you figure out where to cut your rear plastic trim so it fits around the rear post? Did you have to trim anything else to make it fit? Looks great man

Sent from my SM-G950U using Tapatalk

Tbh, I just eyeballed it so my trims are bigger than i expected.