11-08-2021, 06:58 AM | #1 |
Junior Member
Join Date: Nov 2021
Drives: 2013 GT86
Location: Western Cape
Posts: 1
Thanks: 0
Thanked 0 Times in 0 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
Rev counter Trigger
Busy with an engine swap in an 2013 GT86/FRS/BRZ, is all that is needed to get the rev counter to work with standard ECU to connect up the standard sensor on a original style trigger plate? No cam sensors, etc needed?
Have currently a 36-2 trigger plate being used for the engine, so will need to add an additional one fitted or get a electronically made signal from the 36-2. |
11-18-2021, 01:02 AM | #2 |
Member
Join Date: Sep 2021
Drives: brz
Location: Tennessee
Posts: 55
Thanks: 4
Thanked 10 Times in 9 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
2013 uses a vr sensor, 2 wire as far as the plate it may need the same teeth lay out as the fa20 but it may work with your plate.
|
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Counter-intuitive tyre wear... | grumpysnapper | Wheels | Tires | Spacers | Hub -- Sponsored by The Tire Rack | 6 | 03-30-2021 09:30 PM |
ECU flash counter / reset. | FenrirRedsteele | Software Tuning | 3 | 07-19-2018 09:46 PM |
Counter space garage | Lynch8six | User/Vendor/Sponsor Reviews, Feedback, Comments | 25 | 11-10-2015 11:20 AM |
Counter-Strike: GO | MokSpeed | Off-Topic Lounge [WARNING: NO POLITICS] | 0 | 06-09-2014 01:15 PM |
What are you using for over the counter tire shine | BlackyRose | Cosmetic Maintenance (Wash, Wax, Detailing, Body Repairs) | 6 | 08-16-2013 11:34 AM |