Nameless Performance BRZ Axleback Exhaust

[Sportsguy83]

Originally Posted by ayau

hey guys,

i'm planning to go back to the oem muffler with jdm tips. i'll be selling my nameless non-offset for $500 plus shipping ($50 off the original price). it's just a bit too loud for my taste.

Make a thread on the classified section and link it here

[Bamaboy256]

Originally Posted by sportsguy83

@Bamaboy256 read this. Get that front part right now... the sound is glorious, and inside the cabin it is similar to the axleback, just a tad louder.

Will do! How hard was it to jack up the engine?

[Sportsguy83]

Originally Posted by Bamaboy256

Will do! How hard was it to jack up the engine?

I got lost for about two minutes before figuring it out. When you are below the car, you will see the transmission and a bar running sideways with two transmission mounts. Remove a 14 mm nut from the right mount, and jack up the engine by the oil pan. I jacked it up like three times trying to be very careful to not jack it up to much. After that, it fit right on. It really wasn't hard, just need to have the car in stands and have the jack available. I did the install all by myself but a second person would have helped a lot.

[Books]

Originally Posted by Bamaboy256

Will do! How hard was it to jack up the engine?

In addition to sportsguy83's reply, GrimmSpeed made a nice post:
http://www.ft86club.com/forums/showthread.php?t=10111

[Sportsguy83]

Originally Posted by Books

In addition to sportsguy83's reply, GrimmSpeed made a nice post:
http://www.ft86club.com/forums/showthread.php?t=10111

He meant after you have the car in stands, how to raise the engine to fit the downpipe/uppipe combo. BUT, that is a great guide to safely jack our cars!

[Books]

Originally Posted by sportsguy83

He meant after you have the car in stands, how to raise the engine to fit the downpipe/uppipe combo. BUT, that is a great guide to safely jack our cars!

Oops I can't read today

[ayau]

Originally Posted by sportsguy83

Make a thread on the classified section and link it here

here it is

http://www.ft86club.com/forums/showthread.php?t=20446

don't forget that there's no need to wait for nameless to build one

the craftsmanship is amazing. i prefer the look of the oem jdm exhaust tips and feel a little ricerish with the nameless.

damn you @sportsguy83, i should have bought your tips when you were selling lol

[Sportsguy83]

Originally Posted by ayau

the craftsmanship is amazing. i prefer the look of the oem jdm exhaust tips and feel a little ricerish with the nameless.

damn you @sportsguy83, i should have bought your tips when you were selling lol

Man, for real I prefer the look with this 4 inch tips over the 3.38" JDM tips. (Its a subjective so I respect your opinion!!)

Yeah man, I let them go at the end for $85 local (or $100 shipped)!

Good luck, that price is GREAT I think you will find a buyer in no time.

[ayau]

Originally Posted by sportsguy83

Man, for real I prefer the look with this 4 inch tips over the 3.38" JDM tips. (Its a subjective so I respect your opinion!!)

Yeah man, I let them go at the end for $85 local (or $100 shipped)!

Good luck, that price is GREAT I think you will find a buyer in no time.

for whatever reason, i like the look of the thick brimmed jdm tips.

[Sportsguy83]

Originally Posted by ayau

for whatever reason, i like the look of the thick brimmed jdm tips.

I can't fault you for that, they do look PRETTY. When I was deciding on Nameless, I considered sending them my JDM tips so they would weld those instead.

[ayau]

Originally Posted by sportsguy83

I can't fault you for that, they do look PRETTY. When I was deciding on Nameless, I considered sending them my JDM tips so they would weld those instead.

LOL, i considered that too.

[Sportsguy83]

I used the car today with widows down and noticed that coming from a stop, when you blip the throttle a bit more than needed to start, you can notice a bit of boxer rumble. I love the exhaust man, it was well worth the wait.

Sent from my HTC One X

[sierra]

Originally Posted by sportsguy83

I used the car today with widows down and noticed that coming from a stop, when you blip the throttle a bit more than needed to start, you can notice a bit of boxer rumble. I love the exhaust man, it was well worth the wait.

Sent from my HTC One X

I noticed the boxer rumble the first time I started it for the test drive, as it was idling. Nothing like the UEL headers on all the others and but just enough for a DNA signature to the sweet note this engine has by comparison.

[Spaceywilly]

Originally Posted by sportsguy83

I used the car today with widows down and noticed that coming from a stop, when you blip the throttle a bit more than needed to start, you can notice a bit of boxer rumble. I love the exhaust man, it was well worth the wait.

Sent from my HTC One X

Yeah I like the tone of this exhaust more the more I drive it. It has a little bit of the Subaru rumble down low and an almost Porsche like rasp when you step on it. It doesn't sound like anything else out there.