Injector / seal failure or Miss-fire codes.. please post here - Page 24 - Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community

whitefrs · 06-28-2013, 09:18 AM

Quote:

Originally Posted by trueno86power

Crap. I'm in the boat too. Wednesday on the track session I've got the P0351. No particular sound on start up or anything. Cleared it. Yesteday on my way to home I've floor it 3 to 4 WOT. Got it again...

Mods: Perrin EcuTek Flash - aFe Intake - Nameless Fontpipe/Axle back.

I hope the seals are ok

Trust me seals are not good and also check spark plugs as well

Gary in NJ · 06-28-2013, 09:20 AM

Quote:

Originally Posted by trueno86power

I hope the seals are ok

Given the responses to this thread, hope isn't much of a plan. I would inspect the seals and replace the coil pack.

regal · 06-29-2013, 11:09 AM

Going on 7500 miles next month and due for state inspection. Do the dealers have the ECU update now or is it being held up by the EPA? Will just have the local mech do the inspection and diy the oil change if the dealers aren't flashing updates yet.

Carwhisperer · 06-29-2013, 03:16 PM

Quote:

Originally Posted by reeves

I just read through all 14 pages... good luck to all of you who've had this problem. But If you haven't had any symptons/issues of misfiring at this point (I'm up to 23K miles), you've got nothing to worry about right? I got an updated rom file from my tuner that's suppose to help prevent this issue, but how much help is it really at this point?

uh no, I was at 21k miles when it started with me. happened to 2 different injectors within a month of each other.

Carwhisperer · 06-29-2013, 03:18 PM

Quote:

Originally Posted by trueno86power

Crap. I'm in the boat too. Wednesday on the track session I've got the P0351. No particular sound on start up or anything. Cleared it. Yesteday on my way to home I've floor it 3 to 4 WOT. Got it again...

Mods: Perrin EcuTek Flash - aFe Intake - Nameless Fontpipe/Axle back.

I hope the seals are ok

same code I got 2 days before I started getting the popping. Your 1st cylinder isn't getting enough fuel. Take it in SOON.

trueno86power · 07-01-2013, 12:25 PM

Quote:

Originally Posted by Gary in NJ

Given the responses to this thread, hope isn't much of a plan. I would inspect the seals and replace the coil pack.

P0351 came back yesterday with a noticable POP sound. Car stored in the garage and I'll bring it to the dealer soon... I'll update the process.

415FRS · 07-02-2013, 04:46 PM

So my car is supercharged and I am at around 11k miles. I started to hear those pop sound around 1 weeks ago. Where can I take to replace the seal since I no longer under warranty? And how much am i looking to pay? Thanks

Sent from my HTC One using Tapatalk 2

Lonewolf · 07-02-2013, 05:15 PM

Quote:

Originally Posted by 415FRS

So my car is supercharged and I am at around 11k miles. I started to hear those pop sound around 1 weeks ago. Where can I take to replace the seal since I no longer under warranty? And how much am i looking to pay? Thanks

Sent from my HTC One using Tapatalk 2

Did you install the s/c yourself or did a shop do it?

Works (or the place you got your s/c installed) should be able to do it if they order the seal replacement tool kit...

Calum · 07-02-2013, 06:31 PM

I haven't been following this thread so sorry if this has been gone over. Has anyone had a seal go after the new ecu programming?

GTM_Challenge · 07-02-2013, 07:07 PM

Quote:

Originally Posted by Calum

I haven't been following this thread so sorry if this has been gone over. Has anyone had a seal go after the new ecu programming?

No clue, but Im still getting a P0351 on track after flashing a new tune with the new tables.

xjohnx · 07-02-2013, 07:17 PM

Quote:

Originally Posted by GTM_Challenge

No clue, but Im still getting a P0351 on track after flashing a new tune with the new tables.

but you were getting that before, right?

GTM_Challenge · 07-02-2013, 07:25 PM

Quote:

Originally Posted by xjohnx

but you were getting that before, right?

Yes.

Carwhisperer · 07-02-2013, 08:11 PM

Quote:

Originally Posted by GTM_Challenge

Yes.

You ever Gotten P0456 ( very small emission leak ) and no it doesn't seem to be my cap. I've only gotten the P0351 once right before I started having the injector popping begin.

415FRS · 07-02-2013, 08:24 PM

Quote:

Originally Posted by Lonewolf

Did you install the s/c yourself or did a shop do it?

Works (or the place you got your s/c installed) should be able to do it if they order the seal replacement tool kit...

I had a friend helped me out with the installation of the Supercharger. I will contact WORKS soon to see if they have the tool to replace the seal. Thanks.

06-29-2013, 11:09 AM	#325
regal Senior Member Join Date: Jun 2012 Drives: Scion FR-S/Toyota Yaris Location: PA Posts: 1,438 Thanks: 21 Thanked 316 Times in 232 Posts Mentioned: 21 Post(s) Tagged: 0 Thread(s)	Going on 7500 miles next month and due for state inspection. Do the dealers have the ECU update now or is it being held up by the EPA? Will just have the local mech do the inspection and diy the oil change if the dealers aren't flashing updates yet. __________________ 2013 FRS Argento Silver 6MT Mods: Clear fender side lights Tactrix ZA1JB01C 2014 Calib

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Driver's side window seal/door seal	KAB-FRS	Issues \| Warranty \| Recalls / TSB	255	01-01-2021 06:09 PM
FRS-BRZ Port Fuel Injector (interesting)	Element Tuning	Engine, Exhaust, Transmission	50	04-21-2016 04:26 PM
Need Help - 2 codes thrown	jpit	Issues \| Warranty \| Recalls / TSB	3	04-20-2013 12:41 AM
Bulb codes	JDMenrique	Cosmetic Modification (Interior/Exterior/Lighting)	1	02-17-2013 03:25 PM
Dynosty FR-S/BRZ Fuel System Upgrades! Injector Dynamics ID850s!	Dustin@Dynosty	Engine, Exhaust, Bolt-Ons	0	08-21-2012 05:03 PM

07-02-2013, 04:46 PM	#329
415FRS Senior Member Join Date: May 2013 Drives: Red SCion FRS Location: San Francisco Posts: 136 Thanks: 33 Thanked 21 Times in 19 Posts Mentioned: 3 Post(s) Tagged: 0 Thread(s)	So my car is supercharged and I am at around 11k miles. I started to hear those pop sound around 1 weeks ago. Where can I take to replace the seal since I no longer under warranty? And how much am i looking to pay? Thanks Sent from my HTC One using Tapatalk 2

07-02-2013, 06:31 PM	#331
Calum That Guy Join Date: Dec 2011 Drives: 2013 asphalt FRS MT Location: Halifax, Nova Scotia Posts: 4,865 Thanks: 5,058 Thanked 2,867 Times in 1,499 Posts Mentioned: 82 Post(s) Tagged: 1 Thread(s)	I haven't been following this thread so sorry if this has been gone over. Has anyone had a seal go after the new ecu programming?

User Name		Remember Me?
Password