Tuning scheduled for Saturday.
I have a lot to accomplish before then. I need to finish my exhaust, weld in my wideband 02 bung and wire that up, finish my fenders, install new rear rotors, and possibly do an oil change and transmission fluid change.
Hoping my wideband sensor is still okay. It's been tucked away since the header swap, but I left it in the engine bay. Hopefully water didn't reach where it was. Wasn't powered on, so hopefully that will help.
Fender was cut to get rid of a dent that appeared after accidentally forgetting about and running over a wheel chock. Should look a little better with the side skirts attached.