View Single Post
Old 08-18-2021, 07:56 PM   #1
1quickchic
Senior Member
 
Join Date: Jan 2016
Drives: 2013 Panda ft86/FRS
Location: Oklahoma, USA
Posts: 147
Thanks: 22
Thanked 21 Times in 17 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
odd starting issue

Ok looking for an opinion on this, as I'm narrowing down the issue that is at cause
13 frs starts sometimes, then it doesn't, just cranks(engine spinning) nothing
auto car no clutch switch, when it doesn't start can unbolt the 2 grounds in the back on the block and reconnect them and it'll start run etc., then after it sits it repeats.
have added grounds to the di ecu, and to the block
have cleaned the grounds
and cleaned the battery
imob isn't triggering and no key symbol issues
mech fuel pump replace, in tank pump replaced
battery is new, and holding charge, while running it drives fine
it has acted a couple times like its cutting out (losing fuel)
but like said after the reset it if fine again
im leaning towards bad di ecu or main ecu
has no codes i can scan it it when it happens and has nada
1quickchic is offline   Reply With Quote