Quote:
Originally Posted by dewittk
So I have been racking my head against a wall on this one. It started with a worn TO bearing. So I replaced clutch, flywheel, to bearing and clutch fork. After putting ever thing together now all I get is a click from the starter tell me the solenoid is activating but it is not attempting to turn over.
I have already replaced the battery and starter after bench test showed bad starter. Also while checking the electrical system found the ST cut relay which is normally open had shorted at 2 points. So that was replaced after all of this the starter is still clicking.
Anyone have any ideas?
Sent from my SM-G965U using Tapatalk
|
Even though you replaced the battery, I'd suggest you either load test the replacement battery or jump the car's battery (just to insure the engine is getting enough power to turn it over).
Is the clutch switch operating properly?
Are you sure the replacement starter is good?
humfrz