Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB - View Single Post - Build your own baffled Catch can (mishimoto style)

Escobar89 · 09-10-2018, 01:47 PM

Hello,

Thought i could do a guide how to make your own baffled Catch can system. I have been searching a lot about what would be the best solution, depending on if you use FI or NA. I drive my car NA (oft + ofh currently set with the E85 tune), so for my car i think i only need to have a catch can from the pcv system. If i had turbo i think i would have mounted it to the crankcase instead.

I bought a 2-way baffled catch can on Ebay, it's complety universal and are extremly similiar to the mishimoto can.
I ordered a couple of hose fittings since we are using MM instead of inches. But those fittings i used was:
* 10mm for the pcv to inlet
* 12mm for the intake manifold to outlet.
I bought some 10/12mm PVC hose from a local part dealer and then bulided me a attachment/holder made of 2mm stainless steel. I'm not very good at English, so i thought that you might understand better with pictures.
Total cost of everything is an estimated 40 USD.

Feel free to ask me anything!

09-10-2018, 01:47 PM	#1
Escobar89 Member Join Date: Jul 2018 Drives: Subaru BRZ Location: Ronneby, Sweden Posts: 25 Thanks: 1 Thanked 9 Times in 4 Posts Mentioned: 0 Post(s) Tagged: 0 Thread(s)	Build your own baffled Catch can (mishimoto style) Hello, Thought i could do a guide how to make your own baffled Catch can system. I have been searching a lot about what would be the best solution, depending on if you use FI or NA. I drive my car NA (oft + ofh currently set with the E85 tune), so for my car i think i only need to have a catch can from the pcv system. If i had turbo i think i would have mounted it to the crankcase instead. I bought a 2-way baffled catch can on Ebay, it's complety universal and are extremly similiar to the mishimoto can. I ordered a couple of hose fittings since we are using MM instead of inches. But those fittings i used was: * 10mm for the pcv to inlet * 12mm for the intake manifold to outlet. I bought some 10/12mm PVC hose from a local part dealer and then bulided me a attachment/holder made of 2mm stainless steel. I'm not very good at English, so i thought that you might understand better with pictures. Total cost of everything is an estimated 40 USD. Feel free to ask me anything!