08-28-2015, 12:24 PM
|
#164
|
Join Date: Jul 2012
Drives: S2000 CR
Location: Orange County
Posts: 14,530
Thanks: 8,918
Thanked 14,175 Times in 6,834 Posts
Mentioned: 966 Post(s)
Tagged: 14 Thread(s)
|
Quote:
Originally Posted by strat61caster
Can you elaborate a bit? To a non-machinist this implies that all your parts should be 'perfectly' smooth, not like a mirror finish but definitely without obvious evidence of the manufacturing process.
While I think 'ghetto' is harsh, I can see @ abraxis point, on my cascam's I can easily trace the toolpath inside every pocket, front and back, I would not call them smooth.
It's not a knock against you guys, I'm very happy and would definitely buy from you again and recommend your products. I also have no question about the integrity of your parts, I think it would be foolish to question the function of your products based on the form (ironic huh?).
|
I have zero manufacturing experience, but I understand "smooth" to be "no sharp edges".
|
|
|