Quote:
From you post I know you already have read up on this. A few things come to mind:
1. What oil viscosity are you using?
2. Have you done a full ECM reset?
3. Are you running a tune?
4. Check out - S-SB-0033-13 - http://www.ft86club.com/forums/showthread.php?t=45844
From the Service Log -
Some 2013 model year FR-S vehicles may exhibit intake and/or exhaust camshaft position sensor
related and/or engine misfire DTCs (P0340, P0341, P0345, P0346, P0365, P0366, P0390, P0391,
P0301, P0302, P0303, and P0304) due to the camshaft position sensor clearance being out of
specification. In addition, some vehicles may also experience rough idle or extended cranking. This
bulletin provides inspection and repair procedures to address this condition
|
1. I'm not sure what oil they put in when I bought and I haven't put enough miles on it to warrant an oil change, >3k miles on it in the ~2 months that I've had it.
2. NO ECM reset, I'm not sure how to do that.
3. No tune. The car is stock at this point(don't worry, i'll change that sometime soon, maybe)
4. I did read that the other night when I pulled the codes. But it doesn't add up since the symptoms don't seem to match up with the error codes. My thought, and there isn't much documentation on this, but it seems to me that trying to start the car MAY have caused those DTCs.