06-15-2018, 04:50 PM
|
#323
|
Senior Member
Join Date: Jan 2013
Drives: 2013 Subaru BRZ
Location: Miami, FL, USA
Posts: 125
Thanks: 97
Thanked 22 Times in 17 Posts
Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
|
Quote:
Originally Posted by Icecreamtruk
Dont know if we are talking about the same thing, but when my car had that same code and I went to get it diagnosed as soon as the CEL showed (2nd drive cycle, always), all of the target AND measured values dropped to 0. I think the ECU just stops trying to adjust the VTT angles when this code is present. Btw, my car didnt go into limp mode, I could rev it up to redline fine (in fact I did a time attack event with it on), but it was down on power significantly. Based on times I would say at the very least 30-40hp. (2 full seconds slower on a 1min power track).
Edit: I think this doesnt help you much. but what I wanted to get across is that all gauges stopping the reading might not be an error, but that they are indeed reading "0".
|
Same thing. Can redline but definite decrease in power.
|
|
|