I recently installed the SPC 81305 camber bolt. I installed the bolt on the bottom mounting point on the strut, just as the instructions stated. After getting an alignment, the technician stated that he could only achieve -0.4 and -0.7 maximum camber when I wanted -1.5 on both sides.
He stated that if I used the camber bolt on the upper mounting hole, I can get more adjustment. Would it be possible to use this bolt on the top instead? I want to get more negative camber, but do so safely.
This is the exact same one that I purchased.
http://www.ft86speedfactory.com/spc-...front-776.html