02-08-2013, 09:51 AM
|
#279
|
Frosty Carrot
Join Date: Jan 2013
Drives: The Atomic Carrot
Location: Baltimore, MD
Posts: 513
Thanks: 272
Thanked 428 Times in 199 Posts
Mentioned: 19 Post(s)
Tagged: 0 Thread(s)
|
I will 100% support these efforts in any way possible.
Questions:
- Do we have specs for the dealer cable?
- Do we know what ELM chips are used on the boards?
- Do we know what CAN protocol is used on these chips?
- Do we know the available commands for that protocol?
Most systems like this have a run mode and one (or more) diagnostic modes. More questions:
- What are the known modes of operation?
- Which one allows hex-level access to ROM?
- Has anyone successfully enabled this mode? How?
I'm just trying to establish a current status for those new to this adventure?
__________________
If you think you're nerd enough, join in the discussions about Suspension and Aerodynamic modelling!
Wall of Fame - JDL Auto Design, Raceseng, Vishnu Tuning, Penske Shocks, Nameless, Perrin, RaceComp Engineering, Essex/AP Racing, Verus, RacerX
Wall of Shame - aFe Takeda, Wilwood, FA20Club
|
|
|