Quote:
Originally Posted by tinma
To start this off, I am very new to the tuning world so please go easy on me. I'm learning as I go on.
So I did a data log with my OFT of a 3rd gear pull yesterday from 2000rpm to redline.
http://datazap.me/u/tinma/log-147093...-9-10-11-12-13
I added the alarms that are on the OFT Tips & Tricks page and every so often these following alarms go off. I would also like to add that I seem to have backfire every so often coming out of 1st gear.
Alert B ( knock alert & Fuel Trim alert)
For E85 suggest -1 for Petrol may -2
FLKC < -1
Knock Correction < -1
IAM < 0.9
LTFT > +10
LTFT < -10
Alert C running lean alert
you might have to tweak AFR for petrol/E85 try 13 for E85 12.5 Petrol
RPM > 5000
Engine Load > 1
AFR > 13
Select AND at bottom of screen
I dont think the 3rd gear pull log will give me much info on this issue, but I feel like its a step in the right direction. If someone could give me a hand with this, I would greatly appreciate it! @ steve99 or @ Wayno if you have any input on this?
Running on 91oct stage 2 OFT tune with UEL header and drop-in filter
|
When the alarm goes off the offending parameter on the log screen will flash, its like
y flkc knock you have a bit round 4000-5000 in that log.
the load limits not being set looks like your running pretty rich when you get on throttle at lower rpm this may cause the miss fire , it also running on the rich side wot at most rpm, wont hurst just costs you power.
knock is not bad iam is still 1.