View Single Post
Old 10-31-2012, 11:01 AM   #15
gmookher
Banned
 
Join Date: Aug 2012
Drives: VortechSC,BorlaEL,Perrin,GCRace
Location: HighHeatHighAltitudeAZ,USA
Posts: 2,254
Thanks: 458
Thanked 669 Times in 394 Posts
Mentioned: 9 Post(s)
Tagged: 2 Thread(s)
Quote:
Originally Posted by SleekMachine View Post
I installed this like 30 mins ago and I don't like it at all.

The shifter now makes excessive noise - whenever I put it in gear there is now a winding noise. Also, at low rpms you can hear this winding noise. In cabin noise is obnoxiously loud.

When I downshift the winding noise increases significantly and has an extremely large amount of resistance compared to stock; as if I am forcing the gear in. At one point I was worried that I was damaging the gears, so I left it in neutral and braked.

Maybe I'm the only one with this issue, but I'm going to get it removed.

Also, Yes I have it in the correct orientation.
so far sounds like the only one. its a simple install.

post a pic of your install please. that sounds all wrong. Whatever happened i suspect will continue if you reinstall the old part but DO let us know how that goes

something went wrong in your install I think. The part locates the rear end tang in the same location and orientation.
gmookher is offline   Reply With Quote