|
Jaden I am mainly messing with you. As this seems to have you a bit riled up and you have made some blanket statements. With that said some of the stuff you have said I somewhat agree with.
But you can make a 2.0l flow 35lb at 7psi. There are some heads available for other brand 2.0l that flow 400+cfm. With a properly sized turbo behind that head, 72mm you should see every bit of 35lb of flow at 7 psi. But if you are using these parts your goals are well past a few hundred horsepower.
Also if you are using a blower that only flows 55lb, smaller then the initial blower listed, on an engine that justifies the use of an aftermarket head casting, that blower is a restriction at that point. As the engine should have no issues flowing that on its own. Typically those will be used on much higher flowing blower setups. How I stated with a larger blower.
|