|
All of the hardware and bracket should be in the rear cargo area or under floor.
1. Install the bracket loose.
2. Mark the center of the holes. I use a spring loaded awl.
3. Drill the holes - 1/2" drill bit
4. Install drop in expansion anchors - The longer ones.
5. Push the bracket up against the bumper and screw in the 10mm screws
6. Put the plate on with the supplied screws.
There will be two small screws that have 10.9 JH on the heads and two small drop in anchors that you will not use and throw away.
You should be able to go to your local dealer for assistance or where you purchased.
|