Quote:
Originally Posted by cyde01
Yeah, it should be an easy install. I will have to figure out how to wire the wiring harness so that the turn signal works in both the headlight housing and the bumper.
|
the wiring harness just needs a jumper. take the hot wire in for the turn signal and run a spare one down. uses a standard connector pin, and then grab a plug off a totalled FRS and repin the connector to plug in. or dont run a turn indicator to the bumper and leave it as is
when i had vland headlamps with turn signals my frs turn signal on the bumper i left empty. was looking for a delete trim piece