Hi guys,
I just finished installing my v3 kit. Voltmeter beeps upon starting, stays at 28.4. I checked all the connections and they are all good and I made sure they are as tight as possible. However, thr blower does not engage upon activation of the switch when I depress the throttle. When I am driving and engage full throttle, I can hear the clicks but feel nothing, nor does the volt meter readings change.
I am not sure where to start checking for faults. Upon inspection of the throttle switch all soldering points look solid, it is connected, the big red connectors are very tight, the 3 connections going into the blower have been attached as tightly as I can.
Any input is greatly appreciated.
|