Thread
:
2013 FRS | Documented LS2 Swap | How to DIY + Parts List + CANBUS
View Single Post
06-10-2018, 11:23 PM
#
5
spitsnaugle
Senior Member
Join Date: Mar 2018
Drives: LS Swapped Scion FRS = 440HP
Location: Dayton OH
Posts: 298
Thanks: 37
Thanked 276 Times in 134 Posts
Mentioned: 19 Post(s)
Tagged: 0 Thread(s)
Started removing the trans supports. Had to stop to get a right-angle drill adapter from home depot to finish drilling the upper sides, got too tight for my drill.
Not pictured:
THERE IS ONE MORE BRACKET/SUPPORT IMMEDIATELY AFTER THE SHIFTER TO TRIM. Driveshaft will be in contact with it if its ignored.
Last edited by spitsnaugle; 06-06-2019 at
11:41 AM
.
The Following User Says Thank You to spitsnaugle For This Useful Post:
j.F.c.R.a.S
(03-19-2019)
spitsnaugle
View Public Profile
Send a private message to spitsnaugle
Find More Posts by spitsnaugle