View Single Post
Old 09-19-2018, 08:51 AM   #12
Grady
Senior Member
 
Grady's Avatar
 
Join Date: Jun 2017
Drives: BRZ Yellow, 2019 Ranger, 2011 Evora
Location: Dallas
Posts: 1,682
Thanks: 352
Thanked 1,473 Times in 770 Posts
Mentioned: 14 Post(s)
Tagged: 1 Thread(s)
Garage
With the engine running and experiencing a hydro lock I would recomend disassembly. Since you are doing forced induction while you are in there you just as well replace rods/pistons instead of just inspecting. This will cost a lot less than if there is damage and you have the engine come apart later. Stress damage is not always visible.
Grady is offline   Reply With Quote
The Following 2 Users Say Thank You to Grady For This Useful Post:
iceblaze (09-19-2018), Tristor (10-11-2018)