Quote:
Originally Posted by arthur93
Will you be doing an initial group buy for this? If so when would this likely occur? Pricing?
|
No, we are basically just trying to release it as soon as it is ready. Pricing is somewhere around 1650 I think.
Quote:
Originally Posted by Tiz
|
No, you can use the OEM wing (if you want to call it that) and we actually tested it with the Perrin Gurney Flap in CFD
.
I'm sorry again for how long this has taken but we have had a lot of projects going on all at once and like all big projects, this one has taken longer than we anticipated.
The billet uprights are in and after QC they went straight to anodizing. We're pretty happy with how they turned out! Yes, that is a large radius'd leading edge and a knife-edged trailing edge; because aero-nerds. Believe it or not, this does improve efficiency and we ended up purchasing custom tooling for our machinist to be able to do this
.
Thanks,
Eric