@
Shiv@Openflash, do you know if this setting for output percentage can be raised to increase the voltage out? It looks like a 28 to 30 percent increase ought to compensate for the voltage difference between using the switch and using the Procede. @
keen as, I think the way to test this is to create a special throttle map allowing 100 percent at 0 rpms and full throttle. That would allow a true comparison and make adjusting the percentage of compensation more accurate. The throttle connector should be disconnected from the ESC, and the output voltage should be read from that connector instead. See pic below for the output percentage compensation table.