DISCLAIMER: I am NOT responsible for any damage you may do to your car.
DISCONNECT THE BATTERY!!
Pull the rubber molding down around the door frame
Pull the top of the A-pillar trim towards the center of the car. You will see this:
These green clips need to come off:
Rotate 90-degrees with a pliers, and work them out. They can be tough.
Remove the 2 screws holding the visor in place
Using two flat-head screw drivers, push in the slots to pop the clips holding the visor mount in place. You do NOT need to push hard!
Repeat on other side.
Remove the light
This is the adapter you'll need. I bought it off eBay:
http://www.ebay.com/itm/290195434507...S:3160&vxp=mtr
Remove OEM mirror by twisting the base 90-degrees, then sliding down.
Remove OEM clip
Replace with clip from kit
Slide in piece
Put base on, and attach with screws
Pull down the head liner. NOTE, there is a white clip visible once the light comes down. Use your fingers to carefully detach it.
Look in the headliner. Thanks to ft86club member
tonystewart pointing out, there is already a wire harness available. It is held in with blue tape.
There are 3 wires.
Blue: (+) Reverse
White: (+) Positive
Black: (-) Negative
Connect your wires for your mirror and/or radar detector according to the installation manual
Tuck the wires back up, and re-install all the stuff you took down. Once done, slide your mirror on and tighten the screw.
I used a short wire cover that was cut even shorter to hide the wires
Finished product
