Thread: MoTeC FT86
View Single Post
Old 12-18-2013, 03:51 PM   #3
arghx7
Senior Member
 
Join Date: Nov 2011
Drives: car
Location: cold
Posts: 599
Thanks: 72
Thanked 607 Times in 185 Posts
Mentioned: 33 Post(s)
Tagged: 0 Thread(s)
Can you explain how the DI + Port fuel mapping and control logic works? On the most basic level: is it pulsewidth and fuel pressure lookup tables? Or does it calculate a fuel quantity and then figure out what injection is needed to get there?

How is the DI injector flow characterized with regard to pulsewidth and fuel pressure? How much tuning is going to be needed to get the high pressure fuel pump to control fuel setpoint accurately?

Does the system support multiple DI injections? How is the split between the two injections controlled and the start of injection? How does that relate to the port injection control?

How is the tip-in acceleration fuel handled in both port and DI injection modes?
arghx7 is offline   Reply With Quote
The Following User Says Thank You to arghx7 For This Useful Post:
SkullWorks (12-18-2013)